An obstruction shall be permitted between the clear space and the element where the depth of the obstruction is 255 mm (10 in) maximum....
Search Results "Permit"
Filters
Commonly Searched Documents
-
R406.3 Unobstructed Side Reach
-
104.2 Calculation of Percentages
Where the determination of the required size or dimension of an element or facility involves ratios or percentages, rounding down for values less than one half shall be permitted....
-
607.2 Clearance
A lavatory complying with 606 shall be permitted at the control end of the clearance....
-
502.1 General
EXCEPTION: Where parking spaces or access aisles are not adjacent to another parking space or access aisle, measurements shall be permitted to include the full width of the line defining...
-
4.3.8 Changes in Levels
If an accessible route has changes in level greater than 1/2 in (13 mm), then a curb ramp, ramp, elevator, or platform lift (as permitted in 4.1.3 and 4.1.6) shall be provided that complies...
-
Built-up Curb Ramps [4.7.6]
Built-up curb ramps are permitted where they do not project into vehicular traffic lanes or access aisles at parking spaces and passenger loading zones....
-
4.1.6(3)(e)(i)
is technically infeasible to comply with 4.22 or 4.23, the installation of at least one unisex toilet/bathroom per floor, located in the same area as existing toilet facilities, will be permitted...
-
1) Where the Standard specifically refers to 303
vertical rise, the ½" maximum beveled rise with a slope not steeper than 1:2, or changes in level that are ramped in compliance with 405 or 406 are acceptable where changes in level are permitted...
-
Thresholds [§404.2.5]
A maximum height of 3/4” is permitted for existing or altered thresholds if they have a beveled edge on each side with a slope not steeper than 1:2....
-
11B-502.1 General
Exception: Where parking spaces or access aisles are not adjacent to another parking space or access aisle, measurements shall be permitted to include the full width of the line defining...
-
§ 38.125(a)(1) General
., lift, ramp or bridge plate) complying with either paragraph (b) or (c) of this section and sufficient clearances to permit a wheelchair or other mobility aid user to reach a seating location...
-
§ 38.125(a)(2) Exception
The access systems or devices used at a station to which section 37.42 applies must permit compliance with that section....
-
11B-612.2 Bench
Exception: A readily removable bench shall be permitted to obstruct the turning space required by Section 11B-612.3 and the clear floor or ground space required by Section 11B-903.2....
-
§ 38.95(a)(2) Exception
The access systems or devices used at a station to which section 37.42 applies must permit compliance with that section....
-
11B-407.2.1 Call controls
[2010 ADA Standards] EXCEPTION: Existing elevators shall be permitted to have recessed call buttons....
-
11B-809.9.4 Work surfaces
A sink and work surface in a single integral unit 60 inches (1524 mm) minimum in length, is permitted....
-
11B-502.1 General
Exception: Where parking spaces or access aisles are not adjacent to another parking space or access aisle, measurements shall be permitted to include the full width of the line defining...
-
405 Ramps
Alternate slope requirements are permitted for short ramps in existing facilities where space constraints effectively prohibit a 1:12 running slope....
-
1011.2 Clear Ground Space
In alterations, when an entity determines that a condition in 1019 does not permit full compliance with a specific provision in 1011.2, the clear ground space shall comply with the provision...
-
703.2.5 Character Height
EXCEPTION: Where separate raised and visual characters with the same information are provided, raised character height shall be permitted to be ½ inch (13 mm) minimum. ...
-
How to Measure Access Aisles
However, at spaces or access aisles not adjacent to another parking space or access aisle, width measurements are permitted to include the full width of the line defining the parking space...
-
703.2.5 Character Height
[ECTCR UFAS 4.30.4] EXCEPTION: Where separate raised and visual characters with the same information are provided, raised character height shall be permitted to be ½ inch (13 mm) minimum...
-
808.3 Clear Floor Space
EXCEPTION: In alterations, wheelchair spaces are not required to be located within the defined area of raised jury boxes or witness stands and shall be permitted to be located outside these...
-
808.3 Clear Floor Space
EXCEPTION: In alterations, wheelchair spaces are not required to be located within the defined area of raised jury boxes or witness stands and shall be permitted to be located outside these...