This applies to all doors, including bathroom doors, that allow full user passage....
Search Results "Full Length Mirror"
-
11B-224.1.2 Guest room doors and doorways
-
1017.5 Tread Obstacles
Where possible, tread obstacles that cross the full width of the trail tread should be separated by a distance of 48 inches (1220 mm) minimum....
-
1009.4.5 Grab Bars
Grab bars shall be perpendicular to the pool wall and shall extend the full depth of the transfer wall....
-
EXHIBIT G
Language for Sign/Decal QuikTrip is committed to full compliance with the Americans with Disabilities Act (ADA)....
-
224.1.2 Guest Room Doors and Doorways
This applies to all doors, including bathroom doors that allow full user passage....
-
F224.1.2 Guest Room Doors and Doorways
This applies to all doors, including bathroom doors, that allow full user passage....
-
1.3.2 Focus Following NPRM Comments
The MDE Advisory Committee spent the largest portion of its time on these topics, although all topics received full consideration....
-
213.3.1 Toilet Compartments
Full-height partitions and door assemblies can comprise toilet compartments where the minimum required spaces are provided within the compartment....
-
223.1.1 Alterations
In this way, people with disabilities can have access to the full-range of services provided by a medical care facility....
-
Historic Preservation [4.1.7]
Alterations to such facilities are required to be done in full compliance with the alteration requirements for other types of buildings....
-
1017.5 Tread Obstacles
Where possible, tread obstacles that cross the full width of the trail tread should be separated by a distance of 48 inches (1220 mm) minimum....
-
Plain Language Instructions
In any regulation, there is a tension between drafting language that is simple and straightforward and drafting language that gives full effect to issues of legal interpretation....
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
11B-608.2.2 Standard roll-in type shower compartments
roll-in type shower compartments shall be 30 inches (762 mm) wide minimum by 60 inches (1524 mm) deep minimum clear inside dimensions measured at center points of opposing sides with a full...
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
- Kessel Design Linearis Super60 Trench Drain
-
410.6 Real-Time Text Functionality (Section-by-Section Analysis)
In this way, the Board’s approach to requirements for RTT in the proposed rule mirrors the approach taken in the existing 508 Standards and 255 Guidelines toward TTY compatibility....
- Landscape Forms Inc. Scarborough Bench Collection
- Omnia Industries Inc. Interior Modern Lever Latchset - Stainless Steel No.47
-
Table Surface Height
Persons with disabilities considered the 34 inch maximum height too high for surfaces used for any length of time....
-
604.5.2 Rear Wall
The rear grab bar shall be permitted to be 24 inches (610 mm) long minimum, centered on the water closet, where wall space does not permit a length of 36 inches (915 mm) minimum due to the...
-
5.4.5.1 Transfer and Positioning Support Position Recommendation for Imaging Equipment
A positioning support will extend horizontally along the side of the patient scanning/imaging bed/table and be 12 - 16 inches in length and 3 - 6 inches above the transfer surface....
-
Parking Spaces [4.6.3]
The length of accessible spaces is not specified. Access aisles must be as long as the parking space....