Some spaces and buildings are allowed to have one means of egress if the travel distance to an exit is short and the occupant load is low....
Search Results "Bus Loading Zone"
-
Required Means of Egress [IBC §1007.1 (2003), §1003.2.13 (2000)]
-
C. Eligibility for Admission to Vocational Education Centers Based on Residence
Recipients may not establish, approve or maintain geographic boundaries for a vocational education center service area or attendance zone, (hereinafter “service area”), that unlawfully exclude...
-
AJW Architectural Products U674 C-fold/Multifold Towel Dispenser & Waste Receptacle Combination w/ Extended Waste - Recessed
multifold towels Towel dispenser is vanity mounted Product Specs Mechanism Guide / Body: Fabricated of #22 gauge stainless steel that controls paper dispensing by means of 2 spring loaded...
-
Wagner Instruments Mark-10 M3 Digital Force Gauge
Primary force reading - 5 digit Peak force readings - maximum tension & compression Set point force - programmed high & low settings Load...
-
American Standard Colony Choice 1-Handle Kitchen Faucet with Side Spray 4175.701
Large "Comfort Zone": Allows easy fine tuning of temperature. Simple Installation: Fast and easy one person installation. Faucet drops in from top....
-
The Reasonable Modification NPRM
MTA Long Island Bus, 644 F.3d 110 (2d Cir. 2011), subsequently agreed with Melton....
-
Battery-powered Wheelchairs
(g)(1)] If (i) the battery on the passenger’s wheelchair has been labeled by the manufacturer as non-spillable or (ii) the battery-powered wheelchair with a spillable battery can be loaded...
-
Boarding Assistance in General
[Sec. 382.39(a)(1)] Carriers must provide access to the airplane for passengers with a disability by level-entry loading bridges or accessible passenger lounges where these means are...
-
Getting Started
These often include parking for voters, a drop off or loading area, the entrance to the polling place, and the pedestrian routes (both exterior and interior) that voters use to get to the...
-
§ 382.39 Provision of services and equipment
(2) Boarding shall be by level-entry loading bridges or accessible passenger lounges, where these means are available....
-
[2010 ADAS] 105.2.2 ASME
Each of the lift types addressed in ASME A18.1 must meet requirements for capacity, load, speed, travel, operating devices, and control equipment....
-
2. The specific risk must be identified
For example: A person with epilepsy, who has lost consciousness during seizures within the past year, might seriously endanger her own life and the lives of others if employed as a bus driver...
-
1121B.3.1, Item 12
New stations in rapid rail, light rail, commuter rail, intercity bus, intercity rail, high speed rail and other fixed guideway systems (for example, automated guideway transit, monorails...
-
T304 Operable Parts
A transit agency did note that, based on a survey of its existing bus fleet, all operable parts on its buses were already mounted higher than 24 inches....
-
Pressalit Care PLUS Support Arm Fixed Height Swing Grab Bar
Maximum load: 330lbs. (150 kg)...
-
T103 Definitions
“Boarding platform” is a new term for which definition was needed because the final rule, for the first time, addresses accessibility requirements for level boarding bus systems....
-
Sargent HC 8800 Rim Exit Device
It meets the abuse and high wind loads required by South Florida building code. These exits are accepted and approved for use with CURRIES hollow metal doors and McKinney hinges....
-
Bobrick Vandal-Resistant Hook Strip B-985
Four stainless steel hooks snap down for safety if excessively loaded. Furnished with tamper-resistant mounting screws. Unit 18" W, 5 1⁄2" H, 7⁄8" D (455 x 140 x 20mm)....
-
Allen Tel ADA Outdoor Phone with Amplified Receiver and No Dial
Housings are constructed of die cast aluminum and electrostatically deposited enamel finish Handset with 29 inch armored cord, amplified receiver, spring loaded door....
-
Wagner Instruments Mark-10 M4 Digital Force Gauge
Primary force reading - 6 digit Peak force readings - maximum tension & compression Set point force - programmed high & low settings Load...
-
Bobrick Vandal-Resistant Clothes Hook B-983
Hook snaps down for safety if excessively loaded. Back plate 4" W, 4" H, 7/8" D (100 x 100 x 20mm). Hook projects 1 1/4" (30mm) from back plate....
-
Reasonable Modification
Examples of Reasonable Modifications Granting a zoning variance to allow a ramp to be built inside a set-back....
-
4.2 Existing Facilities.
should be noted that "structural changes" include all physical changes to a facility; the term does not refer only to changes to structural features, such as removal of or alteration to a load...
-
Executive Summary
ISO standard 2631-1 specifies zones for how much vibration exposure can be dangerous, but it is unknown how surface roughness can affect the amount of vibration that wheelchair users feel...
