Thresholds above ¼ inch must be beveled with a slope no greater than 1:2....
Search Results "Running Slope"
Commonly Searched Documents
-
Thresholds at Doorways [4.13.8]
-
Verify Rough Plumbing
drain. 11B-607.5 Installation height and location of shower controls. 11B-608.5 Location of shower drains and floor slope...
-
2) Where the Standard says "Changes in level are not permitted"
such as 304.2 for turning spaces: Here the standard is followed by an unenforceable advisory that says, "As used in this section, the phrase ‘changes in level’ refers to surfaces with slopes...
-
4.33.3* PLACEMENT OF WHEELCHAIR LOCATIONS
EXCEPTION: Accessible viewing positions may be clustered for bleachers, balconies, and other areas having sight lines that require slopes of greater than 5 percent....
-
11B-303.3 Beveled
Changes in level between ¼ inch (6.4 mm) high minimum and ½ inch (12.7 mm) high maximum shall be beveled with a slope not steeper than 1:2....
-
11B-1005.1 Accessible routes
length of the gangway or series of gangways serving as part of a required accessible route is 30 feet (9144 mm) minimum, gangways shall not be required to comply with Section 11B-405.2 _|Slope...
- Weizel Security 826-S74 SR™ Partition Door
- Corbin Russwin Inc. BLSS Trim Lever Handle & Lockset
- AJW Architectural Products U591 1.6 Gallon Sanitary Napkin Disposal - Surface Mounted
-
Re: Angled Parking
Requires the Accessibility Specialist plan or above. (Login or upgrade your account!)
-
Suggested accessibility guidelines for exterior concrete surfaces
The deviation from slope or plane of formed surfaces over 10 feet (3 m) is ± 0.3% of length. This is approximately 3/8 inch in 10 feet (10 mm in 3 m)....
- Panda S.51 All Aluminum Folding Door System
- Panda TS.60 Thermally Broken Folding Door System
-
303.3 Beveled
Changes in level between ¼ inch (6.4 mm) high minimum and ½ inch (13 mm) high maximum shall be beveled with a slope not steeper than 1:2. Advisory 303.3 Beveled....
-
Accessible Routes
The accessible route must comply with ADAAG provisions for the location, width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level...
-
Accessible Routes
Accessible route requirements in ADAAG address width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level, doors, egress, and areas...
-
Comments from Individuals Who Are Blind or Have Low Vision (Section-by-Section Analysis)
member of the advisory committee that recommended the proposed guidelines, but filed a minority report recommending detectable warning surfaces should be required only on curb ramps with slopes...
-
Fares
Where bus and rail systems are run by the same provider (or where the same bus provider runs parallel local and express buses along the same route), the comparison would be made to the mode...
-
1133B.5.4.5
Intermediate and bottom landings at a change of direction in excess of 30 degrees shall have a dimension in the direction of ramp run of not less than 72 inches (1829 mm) to accommodate...
-
Elevated Accessible Routes
clear width 32-inch (815 mm) narrowed width permitted for 24-inch (610 mm) length to accommodate features in the composite structure 12-inch (305 mm) rise maximum per ramp run...
-
Disorienting Spaces (slide 7)
It is all just sort of orangy, runs together, very disastrous design change. [In the photo] on the right, it looks like steps. It’s not....
-
Gratings [4.5.4]
Gaps or openings wider than ½ inch should be avoided or else treated, especially where they run parallel to a direction of travel....
- eone Bradley Classic Timepiece