Floor space and location. The minimum floor space provided at a water closet shall be 48 inches (1219 mm) in clear width....
Search Results "Wet Location"
-
1134A.7, Item 1
- Takeform Fusion Signage Overheads Type C
-
11B-608.5.3 Alternate roll-in type shower compartments
and faucets shall be installed on the side wall of the compartment adjacent to the seat wall 19 inches (483 mm) minimum and 27 inches (686 mm) maximum from the seat wall; and shall be located...
-
5. Safety Hazards
Both the library and RecPark programs use daily inspection protocols that address issues deemed to constitute safety hazards, such as wet spots or broken equipment....
-
Polypavement
The material just under the surface of the segment, contains cracks and heaving and stayed wet and therefore soft under foot....
-
11B-405.7.5 Doorways
Where doorways are located adjacent to a ramp landing, maneuvering clearances required by Sections 11B-404.2.4 and 11B-404.3.2 shall be permitted to overlap the required landing area....
-
11B-216.12 Amusement rides
In addition, where accessible unload areas also serve as accessible load areas, signs indicating the location of the accessible load and unload areas shall be provided at entries to queues...
-
11B-405.7.5 Doorways
Where doorways are located adjacent to a ramp landing, maneuvering clearances required by Sections 11B-404.2.4 and 11B-404.3.2 shall be permitted to overlap the required landing area....
-
11B-216.12 Amusement rides
In addition, where accessible unload areas also serve as accessible load areas, signs indicating the location of the accessible load and unload areas shall be provided at entries to queues...
-
Accessibility
The test was performed at a different location each time so that the variability of the results may be seen in large part to the test being run in different locations....
-
Industries Where Safety Training is a Must
Workers may be exposed to flammable gases, high-pressure equipment, and remote locations. ...
-
11B-206.2.8 Employee work areas
Common use circulation paths located within employee work areas that are less than 1000 square feet (93 m2) and defined by permanently installed partitions, counters, casework, or furnishings...
-
11B-221.1 General
Companion seats are required next to each wheelchair seating location. The companion seat is a conventional seat that accommodates a friend or companion....
-
11B-206.2.8 Employee work areas
Common use circulation paths located within employee work areas that are less than 1000 square feet (93 m2) and defined by permanently installed partitions, counters, casework, or furnishings...
-
11B-221.1 General
Companion seats are required next to each wheelchair seating location. The companion seat is a conventional seat that accommodates a friend or companion....
-
11B-604.8.3 Coat hooks and shelves
Coat hooks shall be located within one of the reach ranges specified in Section 11B-308....
-
218 Transportation Facilities
These provisions are based on requirements located in Chapter 10 in the proposed rule....
-
Controls [4.21.5]
Controls [4.21.5] Controls and shower units can be located on any wall but where a folding seat is provided they must be located to be within reach of a person on the seat....
-
11B-611.4 Height
Top loading machines shall have the door to the laundry compartment located 36 inches (914 mm) maximum above the finish floor....
-
11B-604.7.2 Disposal units
Sanitary napkin disposal units, if provided, shall comply with Section 11B-309.4 and shall be wall mounted and located on the sidewall between the rear wall of the toilet and the toilet...
-
1134A.3 Powder rooms
When the powder room is the only toilet facility located on an accessible level, it shall comply with the Option 2 Items listed above, plus all additional requirements located in Sections...
-
§ 38.159(a)(1) General
., lift or ramp) complying with paragraph (b) or (c) of this section and sufficient clearances to permit a wheelchair or other mobility aid user to reach a securement location....