If a person in a wheelchair must make a turn around an obstruction, the minimum clear width of the accessible route shall be as shown in Fig. 7(a) and (b)....
Search Results "Clearance Around Base"
Commonly Searched Documents
-
4.3.3 Width
-
4.1.3 Adjustable Height Chairs with and without Footplates
Because these chairs with footplates are adjustable in height, when the chair height is fully lowered, a minimum 2” clearance is required from the floor to the bottom of the footplate as...
- PEMKO 5" Latching Panic Saddle Threshold No. 2005-T
- PEMKO 5" Latching Panic Saddle Threshold No. 2006-T
-
R402 Protruding Objects (Section-by-Section Analysis)
millimeters (2.25 feet) and 2 meters (6.7 feet) above the finish surface must not overhang pedestrian circulation paths more than 100 millimeters (4 inches) measured horizontally from the base...
-
Registration Table
Registration Table: If a table for registration and handouts is provided, make sure that people with mobility disabilities can approach it and turn around easily to move away again....
-
M. Turning Space
Is there an area in each public restroom in which a person who uses a wheelchair can turn around - either a 60" diameter circle or a "T"-shaped turn area as shown in Figure 3 below?...
-
§ 36.406(f)(2)
seats by section 221.2.3.1 of the 2010 Standards and that have seating encircling, in whole or in part, a field of play or performance, wheelchair spaces and companion seats are dispersed around...
-
USE ZONE
[DSA-AC] The ground level area beneath and immediately adjacent to a play structure or play equipment that is designated by ASTM F 1487 for unrestricted circulation around the play equipment...
-
USE ZONE
[DSA-AC] The ground level area beneath and immediately adjacent to a play structure or play equipment that is designated by ASTM F 1487 for unrestricted circulation around the play equipment...
-
Turning Space [§304]
ride load/ unload areas, fishing piers and platforms, play components, and shooting facilities) Space for turning is also required along accessible routes where a 180 degree turn around...
-
Attachment A: Violations Identified in the United States' Letter of Findings (Sept. 29, 2014)
[See subsections ...]
-
11B-407.4.10.1 Location
Clearance between support rails and adjacent surfaces shall be 1½ inches (38 mm) minimum....
-
ACCESS AISLE
[DSA-AC] An accessible space adjacent to or between vehicle spaces that provides clearances in compliance with this code....
-
306.3.5 Width
Knee clearance shall be 30 inches (760 mm) wide minimum. Figure 306.3 Knee Clearance...
-
11B-604.8.1.2 Doors
Toilet compartment doors, including door hardware, shall comply with Section 11B-404 except that if the approach is from the push side of the compartment door, clearance between the door...
-
Wheeled Mobility Anthropometry Project
specified in the 2004 ADA and ABA Accessibility Guidelines for certain architectural features that involve transfers and that the dimensions for wheelchair spaces, including knee and toe clearance...
-
USE ZONE
[DSA-AC] The ground level area beneath and immediately adjacent to a play structure or play equipment that is designated by ASTM F 1487 for unrestricted circulation around the play equipment...
-
Check-Out Areas [8.3]
Also required: an alternative route at turnstiles accessible gates [4.13.3] on accessible routes access through (or around) book security devices (see page 135)...
-
4.3.3 WIDTH
If a person in a wheelchair must make a turn around an obstruction, the minimum clear width of the accessible route shall be as shown in Fig. 7....
-
§ 35.151(g)(2)
seats by section 221.2.3.1 of the 2010 Standards and have seating encircling, in whole or in part, a field of play or performance area shall disperse wheelchair spaces and companion seats around...
-
General: ADA Standard Section 204.1
Section 204.1 of the ADA Standards covers information on scoping requirements for protruding objects in the most current ADA Standards.
-
10. Clear Floor Space
Is there clear floor space in each accessible guestroom bathroom where persons who use wheelchairs can turn around - either a 60" diameter circle or a "T"-turn area as shown in Figure 3...