[See subsections ...]
Search Results "Car Ramp"
Filters
Commonly Searched Documents
-
11B-235 Recreational boating facilities
-
11B-505.7 Cross section
Handrail gripping surfaces shall have a cross section complying with Section 11B-505.7.1 or 11B-505.7.2.
-
Section 37.42 Service in an integrated setting to passengers at intercity, commuter, and high-speed rail station platforms constructed or altered after February 1, 2012
lifts, ramps or other devices, mini-high platforms (making multiple stops where necessary to accommodate passengers wishing to use different cars of the train), or movable station-based...
-
407.4.6.1 Location
In existing elevators, car control buttons with floor designations shall be permitted to be located 54 inches (1370 mm) maximum above the finish floor where a parallel approach is provided...
-
407.4.6.1 Location
In existing elevators, car control buttons with floor designations shall be permitted to be located 54 inches (1370 mm) maximum above the finish floor where a parallel approach is provided...
-
11B-407.4.6.1 Location
In existing elevators, car control buttons with floor designations shall be permitted to be located 54 inches (1372 mm) maximum above the finish floor when a parallel approach is provided...
-
Q14: Application of Section 504 Safe Harbor to Curb Ramps Built in Compliance with 1991 ADAAG
Q14: Does the Section 504 safe harbor apply to curb ramps built in compliance with 1991 ADAAG during the time period when the requirement for detectable warnings was suspended and the roadway...
-
Sidewalks and Walkways
Some sidewalks do not include curb ramps or, if they do, the ramped section is too narrow or steep....
-
407.4.6.1 Location
In existing elevators, car control buttons with floor designations shall be permitted to be located 54 inches (1370 mm) maximum above the finish floor where a parallel approach is provided...
-
11B-407.4.6.1 Location
In existing elevators, car control buttons with floor designations shall be permitted to be located 54 inches (1372 mm) maximum above the finish floor where a parallel approach is provided...
-
11B-407.4.6.1 Location
In existing elevators, car control buttons with floor designations shall be permitted to be located 54 inches (1372 mm) maximum above the finish floor where a parallel approach is provided...
-
Driving Ranges
driving ranges adjacent to a golf course that provide teeing stations or practice teeing grounds must comply with the following: Accessible Routes—An accessible route or a golf car...
-
Marking: ADA Standard Section 502.3.3
Section 502.3.3 covers the current ADA Standards for marking access aisles.
-
Access Aisle: ADA Standard Section 502.3
Section 502.3 covers the current ADA Standards for access aisles.
-
Length: ADA Standard Section 502.3.2
Section 502.3.2 covers the current ADA Standards for the length of access aisles.
-
11B-502.3.2 Length
Access aisles shall extend the full required length of the parking spaces they serve.
-
12 [§ 4.7.9]
12 [§ 4.7.9] When a curb ramp is located at a marked crossing, the area where the ramp run ends must be contained within the marked crossing....
-
1015.3 Height
On ramps and ramped aisles, from the ramp surface at the guard....
-
1132A.4, Item 4
., concrete, brick, flagstone) may have a maximum change in height from the interior landing of 1 inch (25.4 mm), provided a ramp with a maximum slope of 1:8 is permanently installed....
-
R207.1 General
A curb ramp, blended transition, or a combination of curb ramps and blended transitions complying with R304 shall connect the pedestrian access routes at each pedestrian street crossing....
-
Problem Two (Accessible Route)
Problem Two: The accessible route crosses a curb and no curb ramp is provided. Solution: Install a portable ramp....
-
Where do I measure for a handrail extension?
[emphasis added, typical] The phrase "in the same direction of" the stair flights or ramp runs simply means in the direction of the normal pedestrian flow up/down the stairs or ramp. ...
-
SafePath: Overview of Ramps and Reducers for ADA Compliance by SafePath Products
SafePath™ manufactures ramps, landings, seismic surface transitions, flooring reducers and other industrial and residential products for ADA (American's with Disability Act) and access code...
-
3. Exception to Ramp Running Slope
A ramp in the built environment to which this exception applies may use a 1:2 grade slope on a short rise ramp....
