Is the door hardware (levers, pulls, panic bars, etc.) on all entry doors to accessible guestrooms and other passage doors within the room usable with one hand, without tight grasping, pinching...
Search Results "Means of Entry"
-
G. Door Hardware
-
H. Door Maneuvering Clearance
.: entry door, connecting room door, bathroom doors and other passage doors) in every accessible guestroom/suite, are there at least 18" of clear floor space on the latch side for persons...
-
Site Constraints
An example might include construction of a new infill building with a historic facade which must be maintained (thus predetermining the entry floor level) and where space for a ramp is not...
-
4.13.6 Maneuvering Clearances at Doors
EXCEPTION: Entry doors to acute care hospital bedrooms for in-patients shall be exempted from the requirement for space at the latch side of the door (see dimension “x” in Fig. 25) if the...
-
11B-608.2.3 Alternate roll-in type shower compartments
A 36 inch (914 mm) wide minimum entry shall be provided at one end of the long side of the compartment....
-
11B-807.3.1 Alarms
Exception: Visible alarms shall not be required where inmates or detainees are not allowed independent means of egress....
-
11B-807.3.1 Alarms
Exception: Visible alarms shall not be required where inmates or detainees are not allowed independent means of egress....
-
ASME
ASME A17.1 requires a two-way means of emergency communications in passenger elevators....
-
Alternative Designs
The tub has a non-institutional appearance, a fold-down seat, and a swinging side entry door with a pressurized seal for ease of access....
-
Caution regarding minimum Aisle Widths for aisles that serve "elements on both sides"
The interpretation of the meaning of aisles "serving elements on both sides" might be taken by some AHJs to mean public access to aisles that have self-serve items on both sides of an aisle...
-
804.2.1 Pass Through Kitchen
Pass through kitchens shall have two entries. Figure 804.2.1 Pass Through Kitchens...
-
11B-608.2.3 Alternate roll-in type shower compartments
A 36 inch (914 mm) wide minimum entry shall be provided at one end of the long side of the compartment....
-
M305.3.1.2 Diagnostic Equipment Containing a Wheelchair Space
On diagnostic equipment containing wheelchair spaces with one entry that also serves as the exit, the length of the gripping surface of horizontal standing supports shall be equal to or...
-
E. GRIEVANCE PROCEDURE
Within three (3) months of the entry of this Consent Decree, the County will adopt the attached ADA Grievance Procedure, Attachment C, distribute it to all of its agencies, post it...
-
Door Closers [4.13.10]
Because it may be difficult for a person with a disability to open a door against the resistance offered by a closer, it is important that the closing action be slow enough to allow entry...
-
Press Boxes [§206.2.7]
field or assembly area is no more than 500 sq. ft. if press boxes are either: free-standing and elevated above grade at least 12’ or located in bleachers with points of entry...
-
1132A.4.1 Thresholds
Thresholds at the primary entry and required exit doors shall be no higher than ½ inch (12.7 mm)....
-
§ 38.125(a)(1) General
All intercity rail cars, other than level entry cars, required to be accessible by §§38.111 (a) and (e) of this subpart shall provide a level-change mechanism or boarding device (e.g., lift...
-
§ 38.125(a)(2) Exception
If level-entry boarding, portable or platform lifts, ramps or bridge plates meeting the applicable requirements of this section are provided on station platforms or other stops required...
-
§ 38.95(a)(2) Exception
If level-entry boarding, portable or platform lifts, ramps or bridge plates meeting the applicable requirements of this section are provided on station platforms or other stops required...
-
11B-208.3.3.2
An accessible route from the residential dwelling unit's primary entry door to the vehicular entrance at the garage....
-
608.3.3 Alternate Roll-In Type Shower Compartments
In alternate roll-in type shower compartments, grab bars shall be provided on the back wall and the side wall farthest from the compartment entry....
-
407.2.3.1 Floor Designation
A tactile star shall be provided on both jambs at the main entry level. Figure 407.2.3.1 Floor Designations on Jambs of Elevator Hoistway Entrances...
-
11B-407.2.3.1 Floor designation
A raised star, placed to the left of the floor designation, shall be provided on both jambs at the main entry level. ...