Three dimensions were computed on the right-side for the sub-set of wheelchairs with footrests: Abdomen-Castor edge depth: measured as the horizontal distance from the abdomen to...
Search Results "Horizontal Exit"
-
2. Analysis of footrest clearance height and depth
-
Seating Accommodations
The apparent rationale for this request was to make it more convenient for such passengers to access their personal wheelchairs quickly in order to transfer to another flight or exit the...
-
11B-608.6 Shower spray unit and water
Each shower head shall be installed so it can be operated independently of the other and shall have swivel angle adjustments, both vertically and horizontally....
-
11B-608.6 Shower spray unit and water
Each shower head shall be installed so it can be operated independently of the other and shall have swivel angle adjustments, both vertically and horizontally....
-
1134A.4 Sufficient maneuvering space
required to be adaptable shall provide sufficient maneuvering space for a person using a wheelchair or other mobility aid to enter and close the door, use the fixtures, reopen the door and exit...
-
New Provisions for Employee Work Areas
The proposed rule required such areas to be on an accessible route so that people with disabilities could approach, enter, and exit the space....
-
1133B.2.5.1
SECTION 1133B GENERAL ACCESSIBILITY FOR ENTRANCES, EXITS AND PATHS OF TRAVEL 1133B.2 Doors. 1133B.2.5.1 Door closer. ...
-
Accessible Routes
The accessible route must connect all entry and exit points of accessible play components. ...
-
The September 11, 2001 Wake-up Call
We need to be proactive, and rely as much as possible on ourselves (and not to count on others), to find the exits and to make decisions about our safety....
-
Clear Floor Space [4.35.2]
Space is important so that users can turn around and exit through swinging or sliding doors. Benches can overlap turning space where clearance (9 inches minimum) is available for toes....
-
Employee Work Areas [§206.2.8]
However, these types of employee work areas still must be accessible for “approach, entry, and exit” (§203.9)....
-
1010.1.9.7 Delayed egress locks
An attempt to egress shall initiate an irreversible process that shall allow such egress in not more than 15 seconds when a physical effort to exit is applied to the egress side door hardware...
-
602.6 Water Flow
The angle of the water stream shall be measured horizontally relative to the front face of the unit....
-
1127B.5, Item 4
each curb ramp over its full width to permit safe egress from the ramp surface, or the slope of the fanned or flared sides of the curb ramp shall not exceed one unit vertical in 12 units horizontal...
-
602.6 Water Flow
The angle of the water stream shall be measured horizontally relative to the front face of the unit....
-
11B-602.6 Water flow
The angle of the water stream shall be measured horizontally relative to the front face of the unit....
-
Gratings [4.5.4]
The ½ inch horizontal maximum specified for gratings is a good rule of thumb for these openings as well....
-
Handrails [4.8.5]
Handrails are required on both sides for ramps with a rise more than 6 inches or a horizontal length more than 72 inches....
-
Station 6-Speed
Design speed is critical in determining horizontal and vertical alignments. Speed is also used in calculating necessary sight distances....
-
11B-602.6 Water flow
The angle of the water stream shall be measured horizontally relative to the front face of the unit....
-
1015.2 Where required
equipment platforms, aisles, stairs, ramps and landings that are located more than 30 inches (762 mm) measured vertically to the floor or grade below at any point within 36 inches (914 mm) horizontally...
-
1009.7.2 Separation
The fire-resistance-rated exterior wall construction shall extend horizontally 10 feet (3048 mm) beyond the landing on either side of the landing or equivalent fire-resistance-rated construction...
-
11B-602.6 Water flow
The angle of the water stream shall be measured horizontally relative to the front face of the unit....
-
M301.3 Transfer Supports
Height: Located no less than 6 inches (150 mm) and no more than 19 inches (482 mm) above the patient support surface Horizontal Distance from Transfer Surface: No more than 3 inches (...