In guest rooms having more than 25 beds, 5 percent minimum of the beds shall have clear floor space complying with Section 11B-806.2.3....
Search Results "Extended Floor Surface"
Filters
Commonly Searched Documents
-
11B-224.3 Beds
-
11B-904.4.1 Parallel approach
A portion of the counter surface that is 36 inches (914 mm) long minimum and 34 inches (864 mm) high maximum above the finish floor shall be provided....
-
Neo-Metro Urinal Divider Number 8949-N
The exterior exposed surfaces are poilished to a Satin Finish. White Gloss and Black Matte powdercoating is alternatively available....
-
5.1.4 Transfer Surface Height Measurement
5.1.4 Transfer Surface Height Measurement....
-
Pilot Rock WXT and WXTH Picnic Table Using Aluminum
Full length seats offer full capacity seating which is an advantage over extended top or side access tables. ...
-
Pilot Rock WUT and WUTH Picnic Table - Using Aluminum
Full length seats offer full capacity seating which is an advantage over extended top or side access tables. ...
-
Figure 505.6 Horizontal Projections Below Gripping Surface – Drawing from the U.S. Access Board
-
Smith System Lift Desk Work Surface with Crank
Crank its stable work surface up and the Lift Desk easily accommodates work by a student or teacher in the standing position....
-
4.1.2(17)
(17) If fixed or built-in seating, tables, or work surfaces are provided in accessible spaces, at least 5 percent, but always at least one, of seating spaces, tables, or work surfaces shall...
-
606.2 Clear Floor Space (Exception 3)
606.2 Clear Floor Space (Exception 3) This section requires clear floor space positioned for a forward approach and knee and toe clearance to be provided at lavatories and sinks....
-
Pilot Rock End Accessible Multi-Pedestal Table APT Series 3"x4" Recycled Plastic
These picnic tables have 8 ft. tops which extend 1 foot beyond each end of the 6 ft. seats, 30" table height and 18" seat height (nominal dimensions). ...
-
§ 38.83(a)(1) General
) complying with either paragraph (b) or (c) of this section and sufficient clearances to permit at least two wheelchair or mobility aid users to reach areas, each with a minimum clear floor...
-
7.4.8 Protruding Objects
Constructed features, including signs, shall not extend into the trail tread more than 4 inches (100 mm) between 27 inches (685 mm) and 80 inches (2030 mm) above the surface of the trail...
-
11B-804.3 Kitchen work surface
In residential dwelling units required to comply with Section 11B-809, at least one 30 inches (762 mm) wide minimum section of counter shall provide a kitchen work surface that complies...
-
11B-405.3 Cross slope
Cross slope is the slope of the surface perpendicular to the direction of travel. Cross slope is measured the same way as slope is measured (i.e., the rise over the run)....
-
11B-405.3 Cross slope
Cross slope is the slope of the surface perpendicular to the direction of travel. Cross slope is measured the same way as slope is measured (i.e., the rise over the run)....
-
11B-405.3 Cross slope
Cross slope is the slope of the surface perpendicular to the direction of travel....
-
11B-703.5.6 Height from finish floor or ground
11B-703.5.6 Height from finish floor or ground. Visual characters shall be 40 inches (1016 mm) minimum above the finish floor or ground. Exceptions: 1....
-
904.4.1 Parallel Approach
A portion of the counter surface that is 36 inches (915 mm) long minimum and 36 inches (915 mm) high maximum above the finish floor shall be provided....
-
Seat Width Evaluation
many participants (the 25th through 95th percentiles) for their level, highest and lowest height transfer regardless of the presence or absence of grab bars or a backrest on the transfer surfaces...
-
Pilot Rock WPTS Square Frame Table Using Recycled Plastic
Full length seats offer full capacity seating which is an advantage over extended top or side access tables....
-
Pilot Rock WPTS Square Frame Table Using Lumber
Full length seats offer full capacity seating which is an advantage over extended top or side access tables....
-
Light Rail Platform Slope
The Board has explicitly specified that rail platforms shall slope no more than 1:48 in any direction, consistent with cross slope provisions for walking surfaces in section 403....
-
904.4.1 Parallel Approach
A portion of the counter surface that is 36 inches (915 mm) long minimum and 36 inches (915 mm) high maximum above the finish floor shall be provided....
