Curb ramps and blended transitions must comply with the technical requirements in R302.7 and R304. Ramps must comply with the technical requirements in R407....
Search Results "Curb Line"
Filters
Commonly Searched Documents
-
Components (R302.2) (Section-by-Section Analysis)
-
ALTERNATIVES TO BARRIER REMOVAL
Examples of alternatives to barrier removal include, but are not limited to, the following actions -- §36.305(b)(1) Providing curb service or home delivery; §36.305(b)(2) Retrieving...
-
11B-308.3.1 Unobstructed
Operable parts of fuel dispensers shall be permitted to be 54 inches (1372 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
SafetyStepTD Ramp-Up Detectable Warning System
There is no need to demo and re-pour existing curb ramps to accommodate your ADA truncated dome requirements....
-
Florestone 35-62H Barrier-Free Shower
For barrier-free installation, contractor shall provide ⅝" minimum recess for curb in sub floor. *ADA compliance when accessories installed by manufacturer....
-
Beneficial Designs Public Rights of Way Assessment Process (PROWAP)
Our automated sidewalk assessment process focuses on four areas of liability: Tripping Hazards Curb Ramps Cross Slopes Critical Features When we...
-
Q: If a PSAP uses TTY detection equipment, does it still have to query every silent call with a TTY?
Thus, TTY detection equipment does not eliminate the need for call takers to query every silent line with a TTY....
-
Staff Training
You may have established good policies, but if front line staff are not aware of them or do not know how to implement them, problems can arise....
-
Barrier Removal
Additional information about the rules for "barrier removal" can be found at www.ada.gov/reachingout/lesson41.htm or by calling the ADA Information Line. See Contact Information....
-
382.57 What services must carriers provide if their automated kiosks are inaccessible?
For example, a passenger who cannot use the kiosk could be allowed to come to the front of the line at the check-in counter, or carrier personnel could meet the passenger at the kiosk and...
-
1007.8 Exterior area for assisted rescue
This construction shall extend vertically from the ground to a point 10 feet (3048 mm) above the floor level of the area for assisted rescue or to the roof line, whichever is lower....
-
1003.2.13.7 Exterior area for assisted rescue
This construction shall extend vertically from the ground to a point 10 feet (3048 mm) above the floor level of the area for assisted rescue or to the roof line, whichever is lower....
-
E102.8 TIA (Section-by-Section Analysis)
This standard defines measurement procedures and performance requirements for the handset generated audio band magnetic noise of wire line telephones, including digital cordless telephones...
-
Unified Facilities Guide Specifications
the National Institute of Building Sciences, it is stated that surfaces should be tested with a 4 - meter (12 ft) straightedge in both a longitudinal and transverse direction on parallel lines...
-
Sources of Technical Assistance
Sources of Technical Assistance Department of Justice’s ADA Information Line The ADA Information Line is available during weekdays to provide technical assistance on the ADA Standards...
-
QUESTION: WHAT DOES THE RULE MEAN BY “EXISTING FREIGHT OPERATIONS?”
In addition, where stations serve lines shared by passenger and freight traffic, and a freight train can bypass the track adjacent to the new or altered passenger platform via a gauntlet...
-
308 Reach Ranges
Gas pumps are often located on curbs at least 6 inches high for safety reasons....
-
308.3.1 Unobstructed
Operable parts of fuel dispensers shall be permitted to be 54 inches (1370 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
10.2.1(1)
are constructed at bus stops, bays or other areas where a lift or ramp is to be deployed, they shall have a firm, stable surface; a minimum clear length of 96 inches (measured from the curb...
-
308.3.1 Unobstructed
Operable parts of fuel dispensers shall be permitted to be 54 inches (1370 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
308.3.1 Unobstructed
Operable parts of fuel dispensers shall be permitted to be 54 inches (1370 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
11B-308.3.1 Unobstructed
Operable parts of fuel dispensers shall be permitted to be 54 inches (1372 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
11B-303.3 Beveled
Changes in level exceeding 1/2 inch (13 mm) must comply with Sections 11B-405 (Ramps) or 11B-406 (Curb Ramps). ◼ ...
