(ii) If existing thresholds measure 3/4 in (19 mm) high or less, and are beveled or modified to provide a beveled edge on each side, then they may be retained....
Search Results "High-Contrast Captioning"
Filters
Commonly Searched Documents
-
4.1.6(4)(d)
-
4. Breast Platform Adjustability
The MDE Advisory Committee recommended, by strong majority, a minimum low height of 26 inches and a minimum high height of 42 inches....
-
THREATS AND HAZARDS IN NEW YORK CITY
A dense population and a high volume of built infrastructure amplify the city’s risk. Extreme heat is one of the most common hazards facing NYC....
-
4.2 Physical Accessibility Barriers and Solutions
Barriers Solutions Simple/Low cost Involved / High cost Parking spaces are too narrow Use cones and/or tape and temporary signs to mark...
-
1.1.5 Flatness of walk running slope
ft (1.8 m) wide, measure for flatness of the running slope at 10 ft (3 m) increments along the midpoint of the width of the walk by using a 10 ft (3 m) unleveled straightedge resting on high...
-
11B-407.2.3.1 Floor designation
Raised characters shall be 2 inches (51 mm) high. A raised star, placed to the left of the floor designation, shall be provided on both jambs at the main entry level....
-
11B-407.2.3.1 Floor designation
Raised characters shall be 2 inches (51 mm) high. A raised star, placed to the left of the floor designation, shall be provided on both jambs at the main entry level....
-
11B-803.6 Mirrors
Mirrors shall be full length with a reflective surface 18 inches (457 mm) wide minimum by 54 inches (1372 mm) high minimum and shall be mounted in a position affording a view to a person...
-
407.2.3.2 Car Designations
Tactile characters shall be 2 inches (51 mm) high minimum. Figure 407.2.3.2 Car Designations on Jambs of Destination-Oriented Elevator Hoistway Entrances...
-
2.4 Do Your Research and Offer Suggestions
Suggest simple, low cost solutions as well as bigger high cost solutions. Know your resources, including where to find information on accessible equipment....
-
Food Service Lines [5.5] and Tableware and Condiment Areas [5.6]
Food Service Lines [5.5] and Tableware and Condiment Areas [5.6] Tray slides, if provided, must be no more than 34 inches high....
-
11B-803.6 Mirrors
Mirrors shall be full length with a reflective surface 18 inches (457 mm) wide minimum by 54 inches (1372 mm) high minimum and shall be mounted in a position affording a view to a person...
-
1) Van parking
1) Van parking ADAAG: One in every eight accessible spaces must be wide enough and high enough for a van lift to be deployed....
-
11B-803.6 Mirrors
Mirrors shall be full length with a reflective surface 18 inches (457 mm) wide minimum by 54 inches (1372 mm) high minimum and shall be mounted in a position affording a view to a person...
-
Living Earth Crafts Essex™ Pedicure Chair
electric footrest Reinforced Fiberglass tub with reflexology Embedded control panel Commercial grade chrome plumbing fixtures Luxurious upholstery Contrast...
-
Keypad Buttons
In addition, the Board has included a requirement that the characters provided on buttons comply with visual characteristics specified in section 703.5, which covers finish and contrast,...
-
"Existing Facility" (Section-by-Section Analysis)
In contrast, the term "existing facility" is not defined, although it is used in the statute and the regulations for titles II and III. 42 U.S.C. 12182(b)(2)(A)(iv); 28 CFR 35.150....
-
5. Edge Protection
Advisory Committee made two recommendations for requiring edge protection on raised platforms; for single ramped entry platforms, the Committee recommended requiring a minimum two-inch high...
-
5.1 Public Notification of Availability
Eventually, with public education, printing the international symbol of "communication access" would be sufficient (much like the CC symbol signified "closed captioning")....
-
407.2.3.2 Car Designations
Tactile characters shall be 2 inches (51 mm) high minimum. Figure 407.2.3.2 Car Designations on Jambs of Destination-Oriented Elevator Hoistway Entrances...
-
G. Door Hardware
accessible guestrooms and other passage doors within the room usable with one hand, without tight grasping, pinching, or twisting of the wrist, since many persons with disabilities may not have high...
-
C. Food Service
.: direct counter service) at counters or bars, is there a minimum 60" long portion providing a 27" high knee space, at least 19" deep, with the counter top at 28"-34" above the floor, or...
-
12162(e)(2)(A)(iii) Designation of key stations
in its commuter rail transportation system, in consultation with individuals with disabilities and organizations representing such individuals, taking into consideration such factors as high...
-
4.10.5 Raised and Braille Characters on Hoistway Entrances
Such characters shall be 2 in (50 mm) high and shall comply with 4.30.4. Permanently applied plates are acceptable if they are permanently fixed to the jambs. (See Fig. 20)....
