technical criteria for diagnostic equipment used by patients in a supine, prone, or sidelying position, and M302 provides technical criteria for diagnostic equipment used by patients in a seated...
Search Results "Removable Seat"
-
M301 Diagnostic Equipment Used by Patients in Supine, Prone, or Side-Lying Position; M302 Diagnostic Equipment Used by Patients in Seated Position
-
TOTO® Drake Two-Piece Toilet, 1.6 GPF, Elongated Bowl
• G-Max® fl ushing system, low consumption (1.6GPF/6.0LPF) • Universal Height • Two-piece design with high-profi le tank • Elongated front bowl and tank set, less seat...
-
ADA Safe Harbor Provisions
The exception applies to elements that might otherwise have to be modified under 1) the program access requirement for public entities, 2) the readily achievable barrier removal requirement...
-
Doors at Entrances to Businesses
Doors at Entrances to Businesses Most entrances to stores and businesses use 36 inch wide doors that are wide enough to be accessible. However, some older doors are less than 36...
-
Delta Toilet with FlushIQ Round Front C41903T-WH
electronics and mechanical parts Features ADA compliant chair height bowl to make sitting down and standing up easier 2 in. fully glazed trap-way Round-front bowl with slow-close seat...
-
Knee and Toe Clearance (M303.2.4)
Knee and toe clearance are critical where patients seated in a wheelchair need to position their knees and toes next to or underneath a component of the diagnostic equipment....
-
M303.2.1 Orientation (Section-by-Section Analysis)
The Board did not include requirements for patient body positioning because the diagnostic equipment cannot override the position in which an individual is seated in his or her wheelchair...
-
Location and Size
Each side rail can be removed to permit patients to transfer onto and off of the table, and to permit health care personnel to perform diagnostic procedures....
-
American Standard Right Width 1.28-1.6 gpf FloWise Right Height Elongated Flushometer Toilet
Elongated floor mount flushometer valve toilet, top spud, with seat High Efficiency, Low Consumption operates in the range of 1.28gpf to 1.6gpf (4.8Lpf to 6.0Lpf) Right HeightTM...
-
11B-202.4 Path of travel requirements in alterations, additions and structural repairs
Installing a raised toilet seat. Installing a full-length bathroom mirror. Repositioning the paper towel dispenser in a bathroom. Creating designated accessible parking spaces....
-
11B-233.3.1.2.6 Public housing facility site impracticality
The site impracticality tests in this section may be used to determine the number of required residential dwelling units with adaptable features in buildings without an elevator,...
-
11B-233.3.1.2.6 Public housing facility site impracticality
The site impracticality tests in this section may be used to determine the number of required residential dwelling units with adaptable features in buildings without an elevator,...
-
Highest and Lowest Heights Obtained
The 5th percentile lowest and highest transfers attained were similar to the average WMD seat height (22.1 inch) for all protocols....
-
Addendum G: Comparison of Transfer Abilities between Men and Women
The average wheelchair seat to floor height for men was 22.2 (±1.44) inches and the average height for women was 21.65 (±1.31) inches....
-
11B-206.2.4 Spaces and elements
In assembly areas with fixed seating required to comply with Section 11B-221, an accessible route shall not be required to serve fixed seating where wheelchair spaces required to be on an...
-
11B-206.2.4 Spaces and elements
In assembly areas with fixed seating required to comply with Section 11B-221, an accessible route shall not be required to serve fixed seating where wheelchair spaces required to be on an...
-
11B-206.2.4 Spaces and elements
In assembly areas with fixed seating required to comply with Section 11B-221, an accessible route shall not be required to serve fixed seating where wheelchair spaces required to be on an...
-
G. Chapter 6: Wheelchair Spaces and Securement Systems
Chapter 6 in the 2016 Non-Rail Vehicle Guidelines establishes technical requirements for wheelchair spaces, wheelchair securement systems, and seat belts and shoulder belts provided for...
-
M303.2.3.1 Front or Rear Entry
Where wheelchair space entry and exit is provided at only one end (front or rear) the wheelchair space shall be 48 inches (1220 mm) deep minimum.
-
ABA CHAPTER 9: BUILT-IN ELEMENTS
[See subsections ...]
-
M303.2.3.3 Side Entry
Where wheelchair space entry is only from the side, the wheelchair space shall be 60 inches (1525 mm) deep minimum.
-
M303.2.3.2 Pass Through Entry
Where wheelchair space entry and exit permits pass through from one end to the other, the wheelchair space shall be 40 inches deep (1015 mm) minimum.
-
Chapter 9: Built-In Elements
Chapter 9 covers built-in elements, including dining surfaces and work surfaces (902), benches (903), and sales and service counters (904). Changes made to this section...
-
DIVISION 9: BUILT-IN ELEMENTS
[See subsections ...]
