Ramps or bridge plates 30 inches or longer shall support a load of 600 pounds, placed at the centroid of the ramp or bridge plate distributed over an area of 26 inches by 26 inches, with...
Search Results "Vertical Standing Support"
Commonly Searched Documents
-
§ 38.95(c)(1) Design load
-
F201.3 Temporary and Permanent Structures
Temporary buildings or facilities covered by these requirements include, but are not limited to, reviewing stands, temporary classrooms, bleacher areas, stages, platforms and daises, fixed...
-
Vibrotactile WALK indications
Thus, a pedestrian must be able to stand with a hand on the device while he/she is aligned and waiting to begin crossing....
-
809.5.5.2 Identification
In doors, peepholes that include prisms clarify the image and should offer a wide-angle view of the hallway or exterior for both standing persons and wheelchair users....
-
Evaluate and adjust the volume of the Walk indication
Evaluate and adjust the volume of the Walk indication Stand at the curb or end of the curb ramp at the crosswalk and listen for the Walk indication....
-
809.5.5.2 Identification
In doors, peepholes that include prisms clarify the image and should offer a wide-angle view of the hallway or exterior for both standing persons and wheelchair users....
-
201.3 Temporary and Permanent Structures
Temporary buildings or facilities covered by these requirements include, but are not limited to, reviewing stands, temporary classrooms, bleacher areas, stages, platforms and daises, fixed...
-
§27.71(j)(1)
., each cluster of kiosks and all stand-alone kiosks at the airport) meet this specification....
-
§ 27.71(j)(1)
., each cluster of kiosks and all stand-alone kiosks at the airport) meet this specification....
-
303 Changes in Level
Section 303 addresses vertical changes in level in floor or ground surfaces. No changes have been made to this section....
-
§ 1194.25(j)(1)
(1) The position of any operable control shall be determined with respect to a vertical plane, which is 48 inches in length, centered on the operable control, and at the maximum protrusion...
- American Stair Corp. Standard Railings
- Outdoor Extreme Mobility Beach Cruiser Powered Wheelchair
-
C. Collaboration with Other Entities
Services such as scattered-site supported housing, Assertive Community Treatment (ACT), crisis services, intensive case management, respite, personal care services, behavior support, nursing...
-
11B-219.5 Permanent and portable systems
An adequate number of electrical outlets or other supplementary wiring necessary to support a portable assistive-listening system shall be provided....
-
505.4 Height
Top of gripping surfaces of handrails shall be 34 inches (865 mm) minimum and 38 inches (965 mm) maximum vertically above walking surfaces, stair nosings, and ramp surfaces....
-
Permanently Installed Systems
Vertical wheelchair lifts are differentiated from elevators because they are limited in the height of their vertical lift, are not enclosed, and do not go through a floor level....
-
11B-505.4 Height
Top of gripping surfaces of handrails shall be 34 inches (864 mm) minimum and 38 inches (965 mm) maximum vertically above walking surfaces, stair nosings, and ramp surfaces....
-
11B-505.4 Height
Top of gripping surfaces of handrails shall be 34 inches (864 mm) minimum and 38 inches (965 mm) maximum vertically above walking surfaces, stair nosings, and ramp surfaces....
- Pilot Rock CN-OKR Oak Knoll Collection Trash Receptacle
-
Usable
In addition, companies must provide functionally equivalent access to support services, such as technical support hotlines and databases, call centers, service centers, repair services and...
-
MEANS OF EGRESS
A continuous and unobstructed path of vertical and horizontal egress travel from any occupied portion of a building or structure to a public way....
-
Automatic Operation [4.10.2]
Self-leveling must correct the overtravel or undertravel of a car as it stops at a landing within a ½ inch vertical tolerance since changes in level greater than ½ inch can be troublesome...
-
Q: What is HCO? Who uses it?
HCO can be accomplished by a call taker using standard stand-alone TTY equipment by alternating speaking into the handset and placing the handset in the TTY when the caller types a response...