The shelf shall be capable of accommodating a text telephone and shall have 6 inches (152 mm) minimum vertical clearance in the area where the text telephone is to be placed. 3. ...
Search Results "Vertical Alignment"
Filters
Commonly Searched Documents
-
1117B.2.9
-
3. Exception to Ramp Running Slope
The maximum slope for a ramp in the 2010 Standards is a rise of 1 vertical inch for each 12 inches of horizontal distance slope....
-
17 Inch Low Height
The safest and most easily accessible transfers are those with no or very little horizontal and vertical distance between the seat of the wheelchair and the transfer surface....
-
Ramps M303:3.3, 3.3.1, 3.3.2
Level changes up to ¼ inch high are permitted to be vertical. Level changes between ¼ inch high and ½ inch high would be required to be beveled with a slope not steeper than 1:2....
-
Accessibility Stories by Vijay Gupta
Anyhow, about six months later he went on a fishing trip in Wyoming somewhere, and he slipped on the rock [while he was] fishing and he had vertical fractures in both his legs....
-
Section 35.172 Investigations and compliance reviews. (Section-by-Section Analysis)
Rather than aligning enforcement discretion of title II complaints with the discretion under the enforcement procedures of title III, the commenters favored obtaining additional resources...
-
ThyssenKrupp Elevator Signa 4 Signal Fixtures
within the hoistway HALL FIXTURE UPGRADES: White halo illumination or white button illumination to meet California code Wide range of finishes and alloys 2 round, domed lenses on vertical...
-
Starodub, Inc. Ultra-Light Inertial Profiler (ULIP) for Sidewalks
Guidelines also provide limits and treatments for sidewalk vertical changes (bumps). Local jurisdictions need to assess their sidewalk system relative to ADAAG....
-
[2010 ADAS] 105.2.5 NFPA
elevator hoistways unless they are installed to activate the elevator hoistway smoke relief equipment or where required by Chapter 30 of the California Building Code. 12.3.7 (4) Where the vertically...
-
202.4 Alterations Affecting Primary Function Areas
Florida vertical accessibility requirements of s.553.509, F.S., as incorporated in section 201.1.1 of the code, apply to the path of travel upgrades required by 202.4....
-
Guidelines for Requirement 6
The Department recognizes that reinforcing for grab bars may be accomplished in a variety of ways, such as by providing plywood panels in the areas illustrated, or by installing vertical...
-
2.1.4 Issues
This is not a problem unless induction loops are also installed in the adjacent areas (vertical or horizontal), in which case listeners can be exposed to simultaneous audio signals from...
-
D. Real-Time Text
This proposal represents a significant shift in approach for both the 508 Standards and the 255 Guidelines to better align with current technology....
-
2.3.3 Comparison of Dimensions with Standards and other Anthropometric Studies
• Seat Height, maximum: Compared to the vertical distance measured from the floor to the height of the seat support surface when occupied....
-
Toilet Buildings and Pit Toilets
If the pit toilet has lightweight privacy screens or has no walls, ensure that the riser has vertical or nearly vertical sides and a flat area on each side of the seat that is about 3 inches...
-
NFPA
not exceeding 1000 ft2 (93 m2) in area, a drop installed in the raceway to multiple devices or appliances that does not include any emergency control function devices (4) Where the vertically...
-
Can People with Limited Mobility Use the Usable Circulation Path by Themselves?
Lifts generally have a short vertical travel distance, usually less than 10 feet, and therefore can be an important part of an evacuation....
-
iii. Need for Department action
Voluntary standards have generally proved to be sufficient where obvious business incentives align with discretionary governing standards as, for example, with respect to privacy and security...
-
Base Support [No specific provision—affects M303.2.4]
The green dots in the above scatter plot illustration represent observed values for footrest height, (on the vertical axis) and footrest depth (on the horizontal axis) measured for manual...
-
Use of the International Symbol of Accessibility and Other Signs
If ISA is used, post it on a vertical sign in accordance with ABAAS, section 703.7, in high-contrast colors with a nonglare finish....
-
Road Roughness Measurements
Data processing algorithms converts vertical acceleration measured by the accelerometer to an inertial reference that defines the instant height of the accelerometer in the host vehicle....
-
MARKETING PLAN
The study provides immediately usable data by engineers who employ the various calculations to establish intersection sight triangles, vertical and horizontal curves, and numerous other...
-
DSA IR 16-12: GRAB BAR DESIGN AND CONNECTIONS: 2019 CBC
alternate to Section 2.2 above for grab bars spanning 36” or less between supports, a connection using a back-up plate on the other side of the partition, with two through-bolts spaced vertically...
-
M305.2.2 Length (Section-by-Section Analysis)
In question 19 part (e) the Access Board sought input on whether angled or vertical transfer supports should be permitted. 77 FR at 6925....
