407.1 General (Section-by-Section Analysis) This section addresses accessibility features of operable parts—such as keys and controls—when part of the user interface is hardware....
Search Results "Vehicle Hand Control"
Filters
Commonly Searched Documents
-
407.1 General (Section-by-Section Analysis)
-
II. Rulemaking History
vehicles are readily accessible to and usable by individuals with disabilities....
-
Dyson Airblade Tap Touch-free Faucet and Hand Dryer Plan
Requires the Premium User plan or above. (Login or upgrade your account!) -
5.3.3.2 Location Where Walls Provided
Where walls or partitions are provided, the seat shall be positioned with a wall or partition to the rear and to one side of the seat for a left-hand or right-hand approach. ...
-
1012.1 General
This section contains the technical requirements for parking spaces provided within camping units and picnic units with mobility features and pull-up spaces for recreational vehicles at...
-
11B-812.8.1 Four or fewer
Where four or fewer total EVCS are provided, identification with an International Symbol of Accessibility (ISA) and signs identifying van accessible spaces shall not be required.
-
11B-812.8.1 Four or fewer
Where four or fewer total EVCS are provided, identification with an International Symbol of Accessibility (ISA) shall not be required.
-
27.1 Q. Do the Guidelines set any requirements for the type or location of bathtub controls?
In that case, while the type of control is not specified, the control must be located as shown in Figure 8 of the Guidelines. ...
-
Are the elements of path of travel and accessible routes substantively the same (such as slope, vertical clearance, width of path of travel, etc.)?
EVCS required by CBC Chapter 11B to be accessible must have an accessible route to the facility entrance (see CBC Section 11B-812.5.1) and an accessible route from the vehicle space to the...
-
Dyson Airblade Tap Touch-free Faucet and Hand Dryer Front Elevation
Requires the Premium User plan or above. (Login or upgrade your account!) -
Passenger Loading Zones
The 1991 Standards and the 2010 Standards both include technical requirements for the vehicle pull-up space (96 inches wide minimum and 20 feet long minimum)....
-
10.3.2(4)
the vehicle is at rest, is within plus or minus 1‒1/2 inches under all normal passenger load conditions, and the horizontal gap, measured when the vehicle is at rest, is no greater than...
-
11B-407.4.7.2 Keypads
ETA Editor's Note The preceding CBC requirements for elevator controls at 11B-407.4.6 and 11B-407.4.7 are more stringent than those of 2010 ADA Standards....
-
309.3 Height
309.3 Height. Operable parts shall be placed within one or more of the reach ranges specified in 308.
-
11B-309.3 Height
Operable parts shall be placed within one or more of the reach ranges specified in Section 11B-308.
-
M307.1 General
Operable parts for patient use shall comply with M307.
-
M307.1 General (Section-by-Section Analysis)
This is an introductory section.
-
309.3 Height
Operable parts shall be placed within one or more of the reach ranges specified in 308.
-
309.3 Height
Operable parts shall be placed within one or more of the reach ranges specified in 308.
-
R403.3 Height
R403.3 Height. Operable parts shall be placed within one or more of the reach ranges specified in R406.
-
R403.2 Clear Space
R403.2 Clear Space. A clear space complying with R404 shall be provided at operable parts.
-
404.2.7 Door and Gate Hardware
Handles, pulls, latches, locks, and other operable parts on doors and gates shall comply with 309.4. Operable parts of such hardware shall be 34 inches (865 mm) minimum and 48 inches...
-
309.3 Height
Operable parts shall be placed within one or more of the reach ranges specified in 308.
-
M307.1 General
Operable parts for patient use shall comply with M307.
