All fish models are presented as realistically as possible using modified fiberglass fish mounts similar to trophy fish mounts....
Search Results "Possible Solution"
Filters
Commonly Searched Documents
-
Phase III- Aquarium Exhibit Installation
-
Other Road and Shared Use Path Users
A full evaluation of these devices and vehicles as part of this study was either not possible or unnecessary for one of the following reasons: They are used very infrequently so...
-
III-9.1000 General
the ADA. 4) A State or local agency enforcing a certified code is for practical, but not legal, purposes facilitating compliance with the ADA and helping to eliminate confusion and possible...
-
ASME A18.1 Safety Standard [§410.1]
In the interim, compliance with a later edition of the ASME A18.1 Standard may be possible under the provision for “equivalent facilitation” (§103) only if it is comparable to, or stricter...
-
Transfer Surface Size: Equipment Used by Patients in a Seated Position (M302.2.2)
Comments should include information on sources to support alternative dimensions, where possible....
-
I. Slip Resistant Surface—Aisles, Steps, Floor Areas Where People Walk, Floor Areas in Securement Locations, Lift Platforms, Ramps
While it may not be possible to compare one product directly with another, or to guarantee a constant measure, transit operators or vehicle designers and manufacturers are encouraged to...
-
11B-234.1 General
In those situations, these requirements are to be applied to the extent possible....
-
II-8.3000 Transition plan
Any structural modifications must be completed as expeditiously as possible, but, in any event, by January 26, 1995....
-
11B-234.1 General
In those situations, these requirements are to be applied to the extent possible....
-
Hybrid Surface Systems
The playground owner contacted the manufacturer and was given a solution to apply to the surface to minimize the static electricity. ...
-
405 Ramps
Commenters recommended that language in the original ADAAG be restored calling for the "least possible slope" to be used, with 1:12 being the maximum allowed. Response....
-
(1) Transfer Surface Location for Diagnostic Equipment Used in the Supine, Prone, or Side-lying Position
Evidence presented to the MDE Advisory Committee during its deliberations revealed that it is not always possible to transfer from adjoining sides at the end of the diagnostic equipment...
-
4.2 Stretchers
The Stretchers Subcommittee and full Advisory Committee discussed possibilities for stretcher redesign, emphasizing that current designs should not preclude future innovation....
-
Meeting Purpose
What is the procedure for, after an evacuation, quickly retrieving, as soon as possible, individuals’ mobility devices, service animals and other essential equipment to restore their mobility...
-
Section 37.11 Administrative Enforcement
When it receives such a complaint, the Department will investigate the complaint, attempt conciliation and, if conciliation is not possible, take action under section 504 and/or refer the...
-
American Association of Retired Persons (AARP)
AARP is a nonprofit, nonpartisan organization, with a membership of more than 37 million, that helps people turn their goals and dreams into real possibilities, strengthens communities and...
-
Southwest Louisiana Independence Center (SLIC) - Lake Charles, Leesville, Lafayette, LA
Our Goal To assist individuals with disabilities and the elderly in living positive, productive lives in the community - functioning as independently as possible withing their chosen...
-
AJW Architectural Products UG2-Railing UG2X-Y108 108" Concealed Snap Flange, 1.25" Diameter, Peened Grip - Configuration Y
All mounting of grab bars when possible should have in wall mounting back plates....
-
AJW Architectural Products UG30-Railing UG30X-Y108 108" Concealed Set Screw Flange, 1.5" Diameter, Peened Grip - Configuration Y
All mounting of grab bars when possible should have in wall mounting back plates....
-
AJW Architectural Products UG3-A Series UG3-A12 12" Concealed Snap Flange, 1.5" Diameter Grab Bar - Configuration A
All mounting of grab bars when possible should have in wall mounting back plates. Find centerline mounting points and place bar on line making sure to be on center....
-
AJW Architectural Products UG130-A Series UG130-A12 12" Exposed Flange, 1.5" Diameter Grab Bar - Configuration A
All mounting of grab bars when possible should have in wall mounting back plates. Find centerline mounting points and place bar on line making sure to be on center....
-
AJW Architectural Products UG20-Railing UG20X-Y108 108" Concealed Set Screw Flange, 1.25" Diameter, Peened Grip - Configuration Y
All mounting of grab bars when possible should have in wall mounting back plates....
-
Tile Tech Pavers® Porcelain Pavers™ Series
But with advances in manufacturing techniques and new technology, it is now possible to make porcelain pavers & tiles in a much greater thickness and size, enabling the porcelain pavers...
-
AJW Architectural Products UG2-A Series UG2-A12 12" Concealed Snap Flange, 1.25" Diameter Grab Bar - Configuration A
All mounting of grab bars when possible should have in wall mounting back plates. Find centerline mounting points and place bar on line making sure to be on center....
