For example, a new building constructed between and connected to two existing buildings may have insufficient space to coordinate floor levels and also to provide ramped entry from the public...
Search Results "Entry Point"
Filters
Commonly Searched Documents
-
F206.7.5 Existing Site Constraints
-
206.7.5 Existing Site Constraints
For example, a new building constructed between and connected to two existing buildings may have insufficient space to coordinate floor levels and also to provide ramped entry from the public...
-
502.4 Platform Accessibility Features
Section 9.3.3 Enable sequential entry of multiple (chorded) keystrokes; B. Section 9.3.4 Provide adjustment of delay before key acceptance; C....
-
502.4 Platform Accessibility Features
Section 9.3.3 Enable sequential entry of multiple (chorded) keystrokes. 2. Section 9.3.4 Provide adjustment of delay before key acceptance. 3....
-
1132A.4.1 Thresholds
Thresholds at the primary entry and required exit doors shall be no higher than ½ inch (12.7 mm)....
-
IDEA Center
Occupied length of devices was calculated by computing the dimension from the extreme rear and forward points on the body or chair....
-
Wagner Instruments Mark-10 M3 Digital Force Gauge
Basic Digital Force Gauge Tension & Compression Capacity: 500 lbf / 250 kgf / 2500 N USB Data Output Mesurlite Date Software 50 Date Point Memory...
-
206.4.4.2 Direct Connections
Direct connections to other facilities shall provide an accessible route complying with 404 from the point of connection to boarding platforms and all transportation system elements required...
-
Start Outside
Start Outside Start from site arrival points such as drop-off areas and sidewalks. Determine if there is an accessible route to an accessible entrance....
-
Sargent 8700 Surface Vertical Rod Exit Device
The SARGENT 8700 Surface Vertical Rod Exit Device has two point latching (top and bottom of the door) and is adjustable through the center case....
-
ASI Storage Solutions Traditional Plus Locker
this collection features 14 gauge doors with 16 gauge full-height reinforcement channels, frame-secured 11 gauge frame hooks with protruding padlock hasps, and a maintenance-free, single-point...
-
L. WEB-BASED SERVICES AND PROGRAMS
Within three (3) months of the entry of this Consent Decree, the County will: Designate an employee as the Web Accessibility Coordinator for the County who will be responsible...
-
L. WEB-BASED SERVICES AND PROGRAMS
Within three (3) months of the entry of this Consent Decree, the County will: a....
-
Introduction
Data collection included 3 dimensional measurements of approximately 90 points located on the body and device....
-
4.3.5.3 180-degree turn around an obstacle
The current ADA-ABA standard for the space needed to complete maneuver is based on the width of the entry aisle and the width of the intervening obstacle, e.g. shelving....
-
5.8.2.1 Height of Breast Platform at Time of Measurement
The Committee agreed to this as a “set point” (Identified as “Breast Platform Height” in Figure 5.8.2.1)....
-
C. Boarding and Deplaning Assistance
In addition, you should be aware that when level-entry boarding is not required or if a lift is temporarily not functioning, you must obtain the consent of the passenger with a disability...
-
Distinct Viewing Locations [F246.2, 1015.2, and 1015.3]
Each distinct viewing location must provide a viewing space that is adjacent to the clear ground space through which the point of interest may be viewed....
-
Initial Measures and Transfer Setup
The device seat to floor height was measured as the linear distance between the front of the seat, center-line point on top of the cushion (if present) and the floor (Figure 3 left). ...
-
Producing Printed Material in Large Print
Large print material can be produced by using a photo copier or a computer where an 18-point type size or larger can be selected....
-
206.7.5 Existing Site Constraints
For example, a new building constructed between and connected to two existing buildings may have insufficient space to coordinate floor levels and also to provide ramped entry from the public...
-
11B-206.7.5 Existing site constraints
For example, a new building constructed between and connected to two existing buildings may have insufficient space to coordinate floor levels and also to provide ramped entry from the public...
-
Power-Operated Doors or Gates
Those with doors or gates on opposing sides generally facilitate lift use by permitting a forward approach to both entry and exit doors or gates....
-
M304.2.2 Standing Supports (Section-by-Section Analysis)
In addition, the Access Board has added a new exception for diagnostic equipment with entry and exit that permits pass-through from one end to another to provide one standing support provided...
