Type-304, 18 Gauge Stainless Steel 30" Length x 1-1/2" Diameter with concealed screws Brushed stainless finish Grab bar to wall distance 1-1/2" ADA...
Search Results "Wing Wall"
Filters
Commonly Searched Documents
-
Just Manufacturing 30" Stainless Steel Grab Bar
-
Just Manufacturing 42" Stainless Steel Grab Bar
Type-304, 18 Gauge Stainless Steel 42" Length x 1-1/2" Diameter with concealed screws Brushed stainless finish Grab bar to wall distance 1-1/2" ADA...
-
Just Manufacturing 24" Stainless Steel Grab Bar
Type 304, 18 Gauge Stainless Steel. 24" Length x 1-1/2" Diameter with concealed screws Brushed stainless finish Grab bar to wall distance 1-1/2" ADA Compliant...
-
Just Manufacturing 36" Stainless Steel Grab Bar
Type-304, 18 Gauge Stainless Steel 36" Length x 1-1/2" Diameter with concealed screws Brushed stainless finish Grab bar to wall distance 1-1/2" ADA...
-
Bobrick Recessed Heavy Duty Specimen Pass-Through Cabinet B-50516
Mounts in walls 7" thick with adjustable flange. Type 304 stainless steel, satin finish....
-
Toilet Compartment Access
Doors shall be located in the front partition or in the side wall or partition farthest from the water closet....
-
Section C: Exterior Route
(§302.1) C5 Is the route free of wall mounted objects that protrude more than 4" into the path of travel and are between 27" and 80" high?...
-
A. Introduction
Bush signed into law the Americans with Disabilities Act (“ADA”) saying these words, “Let the shameful wall of exclusion finally come tumbling down.”1 One of the most important civil rights...
-
1136A.2 Switch and control heights
Physical barriers or obstructions shall not extend more than 25 inches (635 mm) from the wall beneath a control....
-
606.2 Clear Floor Space
the following conditions are met: (a) the cabinetry can be removed without removal or replacement of the fixture; (b) the finish floor extends under the cabinetry; and (c) the walls...
-
606.2 Clear Floor Space
the following conditions are met: (a) the cabinetry can be removed without removal or replacement of the fixture; (b) the finish floor extends under the cabinetry; and (c) the walls...
-
Outdoor Rinsing Showers [1011.2, 1011.3, and 1011.7]
The shower pedestal or wall with the shower heads must be at the rear end of the clear ground space. At least one hand-held shower spray unit must be provided....
-
Existing Trails [F247.2]
Maintaining trail tread, such as filling ruts, reshaping a trail bed, repairing a trail surface or washout, installing riprap to retain cut and fill slopes, and constructing retaining walls...
-
Medical Diagnostic Equipment Accessibility Standards Sub-Committee Recommendations Weight Scales
Diagram provided by US Access Board) Dual Ramp Scale (Picture provided by Scale –Tronix) Portable Scales (Picture provided by Scale -Tronix) Wall...
-
Design Guidelines for the Hearing and Visually-Impaired
accessible route into and through the dwelling unit; light switches, electrical outlets, thermostats, and other environmental controls in accessible locations; reinforcements in bathroom walls...
-
606.2 Clear Floor Space
the following conditions are met: (a) the cabinetry can be removed without removal or replacement of the fixture; (b) the finish floor extends under the cabinetry; and (c) the walls...
-
Protruding Objects
Requirements: All objects that protrude from surfaces or posts and all overhanging objects in areas where people walk shall comply with the following requirements: Objects mounted on walls...
-
11B-604.8.1.4 Toe clearance
[2010 ADAS] EXCEPTION: Toe clearance at the front partition is not required in a compartment greater than 62 inches deep with a wall-hung water closet or 65 inches deep with a floor-mounted...
-
1136A.2 Switch and control heights
Physical barriers or obstructions shall not extend more than 25 inches (635 mm) from the wall beneath a control....
-
1136A.2 Switch and control heights
Physical barriers or obstructions shall not extend more than 25 inches (635 mm) from the wall beneath a control....
-
11B-604.8.1.4 Toe clearance
[2010 ADA Standards] EXCEPTION: Toe clearance at the front partition is not required in a compartment greater than 62 inches deep with a wall-hung water closet or 65 inches deep with...
-
105.2.2 ASME
The enclosure walls not used for entry or exit are required to have a grab bar the full length of the wall on platform lifts....
-
105.2.2 ASME
The enclosure walls not used for entry or exit are required to have a grab bar the full length of the wall on platform lifts....
-
Alterations and water closet clearances in single-user toilet rooms with in-swinging doors. (Section-by-Section Analysis)
The 1991 Standards allow a lavatory to be placed a minimum of 18 inches from the water closet centerline and a minimum of 36 inches from the side wall adjacent to the water closet, which...
