The top of the fixture rim shall be a maximum of 34 inches (864 mm) above the finished floor. 2. Floor space....
Search Results "Non-Glare Finish"
Filters
Commonly Searched Documents
-
1134A.8 Lavatories, vanities, mirrors and towel fixtures
-
608.4 Seats
A folding or non-folding seat shall be provided in transfer type shower compartments....
-
232.5.1 Cubicles and Counters
EXCEPTION: The inmate or detainee side of cubicles or counters at non-contact visiting areas not serving holding cells or housing cells required to comply with 232 shall not be required...
-
407.4.8.2.1 Signal Type
[ECTCR UFAS 4.10.13] EXCEPTION: For elevators other than destination-oriented elevators that have a rated speed of 200 feet per minute (1 m/s) or less, a non-verbal audible signal with...
-
R302.7.4 Flangeway Gaps
Flangeway gaps at pedestrian at-grade rail crossings shall be 64 mm (2.5 in) maximum on non-freight rail track and 75 mm (3 in) maximum on freight rail track....
-
608.4 Seats
A folding or non-folding seat shall be provided in transfer type shower compartments....
-
407.4.8.2.1 Signal Type
EXCEPTION: For elevators other than destination-oriented elevators that have a rated speed of 200 feet per minute (1 m/s) or less, a non-verbal audible signal with a frequency of 1500 Hz...
-
R103.3 Units of Measurement
Combining values from the two systems may result in non-compliance....
-
E202.6.1 Required Documentation
The Federal Acquisition Regulation (FAR) sets forth the documentation requirements for a determination of commercial non-availability by federal agencies subject to 508 requirements....
-
13.18 Quality Assurance Inspections
previously-identified standards issues) utilizing each Brand’s quality assurance checklists to verify appearance of items that can be checked in an average half-day review with a visible, non-intrusive...
-
Handrail Clearance and Cross Section [§505.5, §505.7]
Handrails can have circular or non-circular cross-sections, but must have rounded edges. The gripping surface and adjacent surfaces must be free of abrasive or sharp elements....
-
11B-812.7.1 Location
Exception: Where four or fewer total EVCS are provided within a facility, the access aisle for non-angled van accessible spaces may be located on either the driver or passenger side of the...
-
Greg Knoop. Daylighting
It’s funny that a lot of these studies show the glare on the computer....
-
608.2.1 Transfer Type Shower Compartments
Note: Inside finished dimensions measured at the center points of opposing sides Figure 608.2.1 Transfer Type Shower Compartment Size and Clearance...
-
610.2 Bathtub Seats
The top of bathtub seats shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum above the bathroom finish floor....
-
D. Signage
signage will be relocated to between 48 inches measured to the baseline of the lowest tactile character and 60 inches measured to the baseline of the highest tactile character above the finish...
-
407.2.2.2 Visible Signals
Visible signal fixtures shall be centered at 72 inches (1830 mm) minimum above the finish floor or ground....
-
11B-603.5 Accessories
All operable parts, including coin slots, shall be 40 inches (1016 mm) maximum above the finish floor....
-
11B-603.5 Accessories
All operable parts, including coin slots, shall be 40 inches (1016 mm) maximum above the finish floor....
-
Accommodations to Ensure Equal Benefits of Employment
Employment Reasonable accommodations must be provided to enable an employee with a disability to enjoy benefits and privileges of employment equal to those enjoyed by similarly situated non-disabled...
-
References
Any listing of non-governmental resources in this fact sheet should not be construed as an endorsement of the entities, their services or products by the Office of Disability Employment...
-
608.4 Seats
A folding or non-folding seat shall be provided in transfer type shower compartments....
-
E. Reservations
When a person with a disability seeks to book an accessible cabin in a class in which no accessible cabins exist on the ship and the desired class still has non-accessible cabins available...
-
11B-231.4.1 Cubicles and counters
Exception: The detainee side of cubicles or counters at non-contact visiting areas not serving holding cells required to comply with Section 11B-231 shall not be required to comply with...