Handrails that are not continuous must have horizontal extensions at both the top and bottom of the ramp at least 12 inches long that are rounded or returned smoothly to walls, posts, or...
Search Results "Vehicle Ramp"
-
Extensions
-
Chapter 6 Curb Ramps and Pedestrian Crossings Under Title II of the ADA
What does Title II of the ADA require with respect to curb ramps at pedestrian crossings? What are some key characteristics of accessible curb ramps?...
-
10.3.2(4)
the vehicle is at rest, is within plus or minus 1‒1/2 inches under all normal passenger load conditions, and the horizontal gap, measured when the vehicle is at rest, is no greater than...
-
11B-220.2 Point-of-sale devices
Corrects code references for applicable technical requirements for point-of-sale devices, and adds requirement for point-of-sale devices at electric vehicle charging stations....
-
M303.3.3.5 Handrails
Ramps with a rise greater than 6 inches (150 mm) shall provide handrails on both sides....
-
M303.3.3.5 Handrails
Ramps with a rise greater than 6 inches (150 mm) shall provide handrails on each side....
-
Temporary Solutions for Election Day
Problem Two: The accessible route crosses a curb and no curb ramp is provided. Suggestion: Install a portable ramp with edge protection....
-
4.8.5* HANDRAILS
Handrails are not required on curb ramps. Handrails shall comply with 4.26 and shall have the following features: (1) Handrails shall be provided along both sides of ramp segments....
-
Parking Lots
Ensure that curb cuts for ramps are located appropriately—beside, not IN the parking space....
-
11B-406.5.10 Diagonal curb ramps
Diagonal or corner type curb ramps with returned curbs or other well-defined edges shall have the edges parallel to the direction of pedestrian flow....
-
Handrails [§405.8, §505]
Handrails [§405.8, §505] Handrails are required on both sides of ramps with a rise greater than 6”....
-
Where do I measure for a handrail extension?
[emphasis added, typical] The phrase "in the same direction of" the stair flights or ramp runs simply means in the direction of the normal pedestrian flow up/down the stairs or ramp. ...
-
11B-406.5.10 Diagonal curb ramps
Diagonal or corner type curb ramps with returned curbs or other well-defined edges shall have the edges parallel to the direction of pedestrian flow....
-
11B-503.5 Vertical clearance
Vehicle pull-up spaces, access aisles serving them, and a vehicular route from an entrance to the passenger loading zone and from the passenger loading zone to a vehicular exit shall provide...
-
11B-503.5 Vertical clearance
Vehicle pull-up spaces, access aisles serving them, and a vehicular route from an entrance to the passenger loading zone and from the passenger loading zone to a vehicular exit shall provide...
-
Medical Diagnostic Equipment Accessibility Standards Sub-Committee Recommendations Weight Scales
in a wheelchair (M303) Wheelchair space, including orientation, width, depth, knee and toe clearance, and surface slope Changes in level at entry to wheelchair space, including ramps...
-
11B-705.1.2.2.2.2 Two entrance/exit points
Where the turning space has two entrance/exit points other than the sloped ramp segments, detectable warnings shall be 36 inches (914 mm) deep at both entrance/ exit points, as measured...
-
11B-405.5 Clear width
The clear width of a ramp run shall be 48 inches (1219 mm) minimum....
-
11B-405.5 Clear width
The clear width of a ramp run shall be 48 inches (1219 mm) minimum....
-
T603 Wheelchair Securement Systems
The technical requirements in the 2016 Non-Rail Vehicle Guidelines for wheelchair securement systems include provisions on orientation, design load, movement, and rear-facing wheelchair...
-
f-iv
Does the ramp have a level landing at the top and bottom of each ramp section that is at least 60 inches long?...
-
§ 38.113(d)(4) Exception
Retrofitted vehicles shall be coordinated with the platform in existing stations such that the horizontal gap shall be no greater than 4 inches and the height of the vehicle floor, under...
-
11B-406.5.5 Wet conditions
Curb ramps and blended transitions shall comply with Section 11B-405.10....
-
T402.8 Running Slope
The maximum running slope of ramps and bridgeplates shall comply with T402.8.1 or T402.8.2....