The length of transfer supports shall comply with M305.2.2.1 or M305.2.2.2.
Search Results "Sink Height"
Filters
Commonly Searched Documents
-
M305.2.2 Length
-
36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment - Preamble
Published in the Federal Register on January 9, 2017. 36 CFR Part 1195 RIN 3014-AA40 Standards for Accessible Medical Diagnostic Equipment AGENCY: Architectural and...
-
American Standard Cadet 1.1 gpf FloWise Right Height Pressure Assisted Elongated Toilet 2467136
Combination bowl and tank, less seat 12" (305mm) rough EverClean® Surface Elongated bowl Pressure-assisted siphon jet flush action 16-1/2" rim height...
-
HOW TO MEASURE TRANSFER HEIGHTS IS IMPORTANT
HOW TO MEASURE TRANSFER HEIGHTS IS IMPORTANT Many medical examination rooms are equipped with fixed height examination tables, with a typical 32-inch seat height....
-
COSTS TO LOWER MINIMUM TABLE HEIGHT
COSTS TO LOWER MINIMUM TABLE HEIGHT To be useful for its intended purpose, examination tables and chairs must maintain a high height of at least 32 inches, so that the health care provider...
-
Sloan AD-84 Four Station AER-DEC Integrated Sink with Faucet, Soap Dispenser and Hand Dryer
About AER-DEC™ Sinks AER-DEC is the perfect innovation for any high-end washroom....
-
Sloan AD-82 Two Station AER-DEC Integrated Sink with Faucet, Soap Dispenser and Hand Dryer
About AER-DEC™ Sinks AER-DEC is the perfect innovation for any high-end washroom....
-
Sloan AD-83 Three Station AER-DEC Integrated Sink with Faucet, Soap Dispenser and Hand Dryer
About AER-DEC™ Sinks AER-DEC is the perfect innovation for any high-end washroom....
-
Sloan AD-81 Single Station AER-DEC Integrated Sink with Faucet, Soap Dispenser and Hand Dryer
About AER-DEC™ Sinks AER-DEC is the perfect innovation for any high-end washroom....
-
Accessible Medical Equipment
Are height adjustable with a minimum of 17-19 inches from the floor to the top of the cushion? D.2....
-
3.3.6 Knee Clearance Height, minimum
3.3.6 Knee Clearance Height, minimum Knee clearance heights for the four sets of standards range from 650 mm (25.6 in.) (Australia) to 700 mm (27.6 in.) (U.K.) (Figure 3‒6)....
-
Water Flow Height
The minimum 4 inch height is intended to allow use of cups for persons who may need to use them....
-
5.8.3.1 Breast Platform Height Recommendations
5.8.3.1 Breast Platform Height Recommendations The Committee recommends decreasing the minimum height of the top of the breast platform to 26 inches above the floor....
-
Transfer Surface Height (M301.2.1 and M302.2.1)
For many patients who use mobility devices, independent transfer is possible only if the height of the transfer surface is at or near the seat height of their mobility device....
-
11B-1002.6.2 Transfer height
The height of transfer device seats shall be 14 inches (356 mm) minimum and 24 inches (610 mm) maximum measured from the load and unload surface....
-
11B-1002.6.2 Transfer height
The height of transfer device seats shall be 14 inches (356 mm) minimum and 24 inches (610 mm) maximum measured from the load and unload surface....
-
11B-1002.6.2 Transfer height
The height of transfer device seats shall be 14 inches (356 mm) minimum and 24 inches (610 mm) maximum measured from the load and unload surface....
-
M305.2.8 Fittings
Transfer supports shall not rotate within their fittings when in place for transfer.
-
M305.2.7 Clearance
Clearance between the transfer support gripping surface and adjacent surfaces or obstructions shall be 1 ½ inches (38 mm) minimum.
-
M305.2.7 Clearance (Section-by-Section Analysis)
In the MDE NPRM, the Access Board did not provide any specific requirements for clearances around the transfer support. However, in the preamble to the MDE NPRM the Access Board...
-
M305.2.8 Fittings (Section-by-Section Analysis)
The MDE NPRM proposed to require that transfer supports not rotate in their fittings (proposed M305.2.3). Five commenters addressed this provision. Four of the commenters disagreed...
