• Section 4.9.4 of the 1991 Standards requires handrails at the bottom of stairs to continue to slope for a distance of the width of one tread beyond the bottom riser nosing and to further...
Search Results "Running Slope"
2010 ADA Definition
Running Slope: The slope that is parallel to the direction of travel (see cross slope).
Filters
Commonly Searched Documents
-
Section 4.9.4
-
Temporary Solutions For Emergency Sheltering - Ramps
Suggestion: Install a portable ramp with a slope no steeper than 1:12 with edge protection. Store the portable ramp on site so it can be easily accessed in an emergency....
-
Instrumentation for Analysis
An on-site inspection form (Appendix C) was created to collect information on the nine locations identifying deficiencies in slope, cross slope, changes in level and openings in the surface...
-
2. Typical Issues for Individuals Who Are Blind or Have Low Vision
These objects must be positioned so people will either detect the objects before they run into them or safely pass under them....
-
Part 2. Typical Issues for Voters Who Are Blind or Have Low Vision
that project into a pedestrian route from the side, or that are overhead must be located so that people who are blind or who have low vision will either detect the objects before they run...
-
505.10.3 Bottom Extension at Stairs
At the bottom of a stair flight, handrails shall extend at the slope of the stair flight for a horizontal distance at least equal to one tread depth beyond the last riser nosing....
-
505.10.3 Bottom Extension at Stairs
At the bottom of a stair flight, handrails shall extend at the slope of the stair flight for a horizontal distance at least equal to one tread depth beyond the last riser nosing....
-
11B-812.3 Floor or ground surfaces
Changes in level, slopes exceeding 1:48, and detectable warnings shall not be permitted in vehicle spaces and access aisles....
-
Konica Minolta's Bizhub Informational Video
This digital press series provides quick and efficient printing of short run materials without the need to make or change plates required with offset printing while maintaining the color...
-
G. Drop-off Area
If the lodging facility has covered passenger pickup/drop-off areas, does the pavement at such area(s), including the required 5' wide access aisle, slope 1:50 or less (critical dimension...
-
1(3)(a)(ii)
building is an elevator building which is a covered multifamily dwelling, and the elevator in that building must provide accessibility to all dwelling units in the building, regardless of the slope...
-
C1-d
[ADA Standards § 4.3.8] Yes No Note: Level changes between 1/4 inch and 1/2 inch should be beveled (sloped) at 1:2 maximum....
-
240.2.1 Ground Level Play Components
Where ramps connect elevated play components, the maximum rise of any ramp run is limited to 12 inches (305 mm)....
-
11B-240.2.1 Ground level play components
Where ramps connect elevated play components, the maximum rise of any ramp run is limited to 12 inches (305 mm)....
-
F240.2.1 Ground Level Play Components
Where ramps connect elevated play components, the maximum rise of any ramp run is limited to 12 inches (305 mm)....
-
240.2.1 Ground Level Play Components
Where ramps connect elevated play components, the maximum rise of any ramp run is limited to 12 inches (305 mm)....
-
11B-240.2.1 Ground level play components
Where ramps connect elevated play components, the maximum rise of any ramp run is limited to 12 inches (305 mm)....
-
11B-240.2.1 Ground level play components
Where ramps connect elevated play components, the maximum rise of any ramp run is limited to 12 inches (305 mm)....
-
4.13.8* Thresholds at Doorways
Raised thresholds and floor level changes at accessible doorways shall be beveled with a slope no greater than 1:2 (see 4.5.2)....
-
Head Room [4.4.2]
This is important at open stairways and along sloped walls....
-
Special Technical Provisions for Alterations to Existing Buildings and Facilities [4.1.6(3)]
Section 4.1.6(3) recognizes certain allowances where technical feasibility is encountered, such as steeper slopes for short ramps....
-
4.13.8* THRESHOLDS AT DOORWAYS
Raised thresholds and floor level changes at accessible doorways shall be beveled with a slope no greater than 1:2 (see 4.5.2)....
-
11B-608.9 Shower floor or ground surface
Floor or ground surfaces of showers shall comply with Section 11B-302.1 and shall be sloped 1:48 maximum in any direction....
-
1016.4 Passing Spaces
Where passing spaces and resting intervals overlap, the technical requirements for resting intervals in 1016.8.3 require the slope of the surface to not be steeper than 1:48 in any direction...
