The running slope of walking surfaces shall not be steeper than 1:20. The cross slope of walking surfaces shall not be steeper than 1:48....
Search Results "Ramp Surface"
Filters
Commonly Searched Documents
-
11B-403.3 Slope
-
T402.7 Edge Guards
Ramps and bridgeplates shall provide edge guards continuously along each side of the ramp or bridgeplate to within 3 inches (75 mm) of the end of the ramp or bridgeplate that is deployed...
-
11B-405.7.4 Change in direction
Ramps that change direction between runs at landings shall have a clear landing 60 inches (1525 mm) minimum by 72 inches (1829 mm) minimum in the direction of downward travel from the upper...
-
11B-405.7.4 Change in direction
Ramps that change direction between runs at landings shall have a clear landing 60 inches (1525 mm) minimum by 72 inches (1829 mm) minimum in the direction of downward travel from the upper...
-
A4.8.1 General
Ramps are essential for wheelchair users if elevators or lifts are not available to connect different levels....
-
4.7.9 Location at Marked Crossings
Curb ramps at marked crossings shall be wholly contained within the markings, excluding any flared sides (see Fig. 15). ...
-
A4.8.1 GENERAL
Ramps are essential for wheelchair users if elevators or lifts are not available to connect different levels....
-
4.7.9 LOCATION AT MARKED CROSSINGS
Curb ramps at marked crossings shall be wholly contained within the markings, excluding any flared sides (see Fig. 15). Figure 15 Curb Ramps at Marked Crossings...
-
A4.8.4 Landings
A ramp landing that is not level causes individuals using wheelchairs to tip backward or bottom out when the ramp is approached....
-
1011.5.2 Cooking Surfaces
Where provided, cooking surfaces shall be 15 inches (380 mm) minimum and 34 inches (865 mm) maximum above the ground....
-
1011.5.2 Cooking Surfaces
Where provided, cooking surfaces shall be 15 inches (380 mm) minimum and 34 inches (865 mm) maximum above the ground....
-
UltraPlay Recycled Rubber Tile Surface
Allows for individual tile replacement Superior shock absorption characteristics Provide a guaranteed critical fall height value Is a good solution for playgrounds erected on a smooth surface...
-
Location at Marked Crossings [4.7.9]
The foot of a curb ramp must be contained within the crosswalk, where one is marked....
-
R409.1 General
Handrails required at ramps and stairways, and handrails provided on pedestrian circulation paths shall comply with R409. Advisory R409.1 General....
-
WoodCarpet Ground Surface System: WoodCarpet Mat Installation Video
-
406.8 Detectable Warnings
A curb ramp shall have a detectable warning complying with 705....
-
3.2.4 Slope
The ground surface in all camp living areas shall have a slope of no more than 1:48 (2 percent) in any direction. Exception....
-
NanoPave® 2-in-1 Joint Stabilizer and Sealer
NP-JSS is a UV resistant, VOC-free sealant that protects and helps maintain the natural beauty of most paving surfaces....
-
§ 38.159(c)(5) Slope
Ramps shall have the least slope practicable and shall not exceed 1:4 when deployed to ground level....
-
11B-302.3 Openings
Openings in floor or ground surfaces shall not allow passage of a sphere more than ½ inch (12.7 mm) diameter except as allowed in Sections 11B-407.4.3, 11B-409.4.3, 11B-410.4, 11B-810.5.3...
-
Why a smooth surface door or kickplate is important
And those nicks slice your fingers like butter when you least expect it.
-
Maximum Slope at Ground Level
A berm may be a natural sloped surface that is present in a hilly play area site, or a ground-level route built with slopes....
-
(3) Adjustability: Transfer Surface Intermediate Heights
In the MDE NPRM there was no requirement for the transfer surface to have intermediate transfer heights....
-
Exterior Routes
EXTERIOR ROUTES Floor and ground surfaces stable, firm and slip resistant. 11B-302.1 Openings in floor or ground...
