In alternate roll-in type shower compartments, grab bars shall be provided on the back wall and the side wall farthest from the compartment entry....
Search Results "One Step Entry"
-
11B-608.3.3 Alternate roll-in type shower compartments
-
Maneuvering Clearances [§404.2.4]
Clearance beyond the latch side is not required at entry doors to hospital patient rooms. ...
-
11B-804.2.1 Pass through kitchen
Pass through kitchens shall have two entries....
-
11B-804.2.1 Pass through kitchen
Pass through kitchens shall have two entries....
-
608.2.2 Standard Roll-In Type Shower Compartments
30 inches (760 mm) wide minimum by 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides and shall have a 60 inches (1525 mm) wide minimum entry...
-
804.2.1 Pass Through Kitchen
Pass through kitchens shall have two entries....
-
II. Recommendations of Diagnostic Imaging Equipment Manufacturers on Transfer Surface Low Height
One of the goals of the study was to “determine acceptable ranges for non-level transfers (e.g. vertical height differences)”....
-
D. Notification – Alerting the Public to an Emergency
Often, using a combination of notification methods will be more effective than relying on one method alone....
-
Expert opinion on the current literature
Articles that both experts agreed were relevant to the performance of independent wheelchair transfers were selected for the next step of review....
-
Executive Summary
Performing the task of transferring oneself from one surface to another is highly essential for wheeled mobility device users in order to accomplish everyday activities such as going to...
-
1.15 Stadium-style seating, stadium section, or stadium seating
Each row of stadium seating is elevated above the row immediately ahead of it and is accessed by stepped, rather than sloped, aisles....
-
Common Problems with Routes to Building Entrances
Common Problems with Routes to Building Entrances Ø The route has steps but no ramp....
-
K. Eating Areas
Eating Areas An accessible route, at least 36 inches wide and without steps or steep slopes, must be provided to and throughout the food service and eating areas of the shelter....
-
§ 38.101(b)
outside lights which, when the door is open, provide at least 1 footcandle of illumination on the station platform surface for a distance of 3 feet perpendicular to all points on the bottom step...
-
§ 37.131(a)(3) Jurisdictional boundaries
The entity shall take all practicable steps to provide paratransit service to any part of its service area....
-
§ 38.157(b)
doorway shall have outside light(s) which, when the door is open, provide at least 1 foot-candle of illumination on the pathway to the door for a distance of 3 feet (915 mm) to the bottom step...
-
§ 38.109 Between-car barriers
operate in a high-platform, level-boarding mode, and where between-car bellows are not provided, devices or systems shall be provided to prevent, deter or warn individuals from inadvertently stepping...
- Sennheiser GZR 2020 Trolley for TourGuide Receivers and Transmitters Charging Case
-
11B-407.2.3.1 Floor designation
A raised star, placed to the left of the floor designation, shall be provided on both jambs at the main entry level....
-
11B-407.2.3.1 Floor designation
A raised star, placed to the left of the floor designation, shall be provided on both jambs at the main entry level....
- ALUMAT Magnetic Doors Seals for External Doors
-
Unisex (Single-Use or Family) Toilet and Unisex Bathing Rooms: ADA Standard Section 213.2.1
Section 213.2.1 covers scoping requirements in the current ADA Standards for unisex (single-use or family) toilet and unisex bathing rooms.
-
Treads and Risers [4.9.2], Nosings [4.9.3]
Uniformity is important not only between steps but along each step; curved stairs, where the width of each tread varies, do not meet this requirement....
-
M305.3.1 Length (Section-by-Section Analysis)
First, for diagnostic equipment containing wheelchair spaces with one entry that also serves as the exit, the length of the gripping surface for horizontal standing supports must be equal...