Install tableware, dishware, condiment, food and beverage display shelves, and dispensing devices in compliance with 4.2 (see Fig. 54).
Search Results "Reach Range"
-
5.3 TABLEWARE AREAS
-
Trailhead Information Signs [F216.13 and 1017.10]
requires operable parts in accessible spaces to comply with the technical requirements for operable parts in section 309 of the ABA Standards, including the provisions for clear ground space, reach...
-
5.4 VENDING MACHINES
Install vending machines in compliance with 4.27.
-
Card Catalogs and Magazine Displays [8.4]
The preferred maximum reach height for card catalogs is 48 inches (recognizing that users may be lifting or manipulating card drawers)....
-
5.5 Food Service Lines
If self-service shelves are provided, at least 50 percent of each type must be within reach ranges specified in 4.2.5 and 4.2.6....
-
5.6 Tableware and Condiment Areas
Self-service shelves and dispensing devices for tableware, dishware, condiments, food and beverages shall be installed to comply with 4.2 (see Fig. 54).
-
407.2.1.1 Height
Call buttons and keypads shall be located within one of the reach ranges specified in 308, measured to the centerline of the highest operable part....
-
5.8 Vending Machines and Other Equipment
Spaces for vending machines and other equipment shall comply with 4.2 and shall be located on an accessible route.
-
Guidelines for Requirement 5
The ANSI Standard presents reach ranges for both forward and side approaches for two situations: (1) unobstructed; and (2) over an obstruction. ...
-
Reach Ranges and Operability Requirements
In this guidebook, you will see the provision "Controls and operating mechanisms must comply with the requirements for reach ranges and operability specified in ABAAS, sections 308 and 309...
-
Grab Bars
Grab bars must comply with the reach range requirements of ABAAS, section 308, as explained in "Reach Ranges and Operability Requirements."...
-
407.12 Reach Height (Section-by-Section Analysis)
Specifically, this section would establish requirements for position (i.e., vertical reference plane), forward reach, and side reach....
-
407.12.1 Vertical Reference Plane (Section-by-Section Analysis)
407.12.1 Vertical Reference Plane (Section-by-Section Analysis) This section proposes that the positioning of operable parts for side reaches and forward reaches be determined with respect...
-
Trash, Recycling, and Other Essential Containers
Ensure controls and operating mechanisms for containers comply with the technical requirements for reach ranges and operability specified in ABAAS, sections 308 and 309, and explained in...
-
Utilities at Recreation Sites
Ensure controls and operating mechanisms for utilities comply with the technical requirements for reach ranges and operability specified in ABAAS, sections 308 and 309, which are explained...
-
Water Hydrants
Standard handpumps require a force greater than 5 pounds (2.2 newtons) and a long reach to operate....
-
Utility Sinks
If utility sinks are provided in a recreation facility that also contains a cook top or conventional range, at least 5 percent (but not less than 1) in each accessible room or space must...