curb height, including but not limited to, toll booths that are accessed only by underground tunnels, shall not be required to comply with these requirements or to be on an accessible route...
Search Results "Pedestrian Route"
-
F203.7 Single Occupant Structures
-
203.6 Single Occupant Structures
curb height, including but not limited to, toll booths that are accessed only by underground tunnels, shall not be required to comply with these requirements or to be on an accessible route...
-
11B-203.6 Single occupant structures
curb height, including but not limited to, toll booths that are accessed only by underground tunnels, shall not be required to comply with these requirements or to be on an accessible route...
-
11B-203.6 Single occupant structures
curb height, including but not limited to, toll booths that are accessed only by underground tunnels, shall not be required to comply with these requirements or to be on an accessible route...
-
203.6 Single Occupant Structures
curb height, including but not limited to, toll booths that are accessed only by underground tunnels, shall not be required to comply with these requirements or to be on an accessible route...
-
Common Problems Arising in the Installation of Accessible Pedestrian Signals
of accessible pedestrian signals (APS)....
-
Pushbutton locator tone
locator tone The pushbutton locator tone is a low-volume tick or tone that repeats constantly, at one-second intervals, during the flashing and steady DON’T WALK intervals to advise pedestrians...
-
Location
Source: NCHRP Web Only Document 117-A, Accessible Pedestrian Signals: A Guide to Best Practice, Figure 6-8 Figure 4: Installation of APS on two separated poles, aligned with crosswalk...
-
401 General
401 General
-
401 General
[See subsections ...]
-
401 General
[See subsections ...]
-
11B-401 GENERAL
[See subsections ...]
-
A4.3.1 General
[See subsections ...]
-
A4.3.1 GENERAL
[See subsections ...]
-
11B-401 General
[See subsections ...]
-
11B-401 General
[See subsections ...]
-
R302.3 Continuous Width
Except as provided in R302.3.1 and R302.3.2, the continuous clear width of pedestrian access routes shall be 1.2 m (4.0 ft) minimum, exclusive of the width of the curb....
-
R202.1 General
Where elements are altered or added and the pedestrian circulation path to the altered or added elements is not altered, the pedestrian circulation path is not required to comply with R204...
-
Issue 8: Rest-in-WALK (quiet time ok)
Issue 8: Rest-in-WALK (quiet time ok) In some locations, the pedestrian signals ‘rest-in-WALK’ and it may not be desirable to have the WALK indication repeat constantly during the long...
-
Synthesis of Literature Relevant to Roundabout Signalization to Provide Pedestrian Access - Final Report
Prepared by: Vaughan W. Inman Science Applications International Corporation and Gregory W. Davis Federal Highway Administration, RD&T 6300 Georgetown...
-
R209.2 Alterations
Existing pedestrian signals shall comply with R209.1 when the signal controller and software are altered, or the signal head is replaced....
-
Newly Constructed Tabled Intersections That Contain Pedestrian Street Crossings With Yield or Stop Control (Section-by-Section Analysis)
applies to pedestrian access routes within pedestrian street crossings with yield or stop control where vehicles slow or stop before proceeding through the intersection....
-
Issue 3: Which signal? Speech WALK messages necessary
Pedestrians standing at one crosswalk could mistake the message of the other crosswalk for their indication to begin crossing....
-
R302.5 Grade
Except as provided in R302.5.1, where pedestrian access routes are contained within a street or highway right-of-way, the grade of pedestrian access routes shall not exceed the general grade...