Many variables affect the performance of a given walking surface, including slope and cross slope, its material, jointing, texture, and finish, the presence of moisture or contaminants,...
Search Results "Slope"
Filters
Commonly Searched Documents
-
General [4.5.1]
-
Exemptions for Entire Trail or Beach Access Route
The proposed rule would have exempted an entire trail from complying with the technical requirements for trails when: The combination of running slope and cross slope exceeds 40...
-
Installation of Aggregate Surfaces at Bradford Woods
Woods conformed to the following protocol: Prior to installing the crushed rock (aggregate) surfacing material, the trail bed shall be shaped to reflect the same linear grade and cross slope...
-
Summary: What Every Playground Owner Should Know About the Accessibility of Their Playground Surfaces
The areas should be checked for compliance with running slope, cross slope, changes in level and openings. Comparison shopping is essential in the planning process....
-
Using the Conditions for an Exception in FSORAG
The terrain makes it impossible to meet the technical requirement for running slope without severe cuts or fills....
-
When is a Curb Ramp a Ramp?
[DSA-AC] A sloping pedestrian way, intended for pedestrian traffic, which provides access between a walk or sidewalk and a surface located above or below an adjacent curb face. 1991 &...
-
Benches
Do not allow the slope of the clear floor or ground space to exceed 1:48 (2 percent) in any direction, except if the surface isn't paved or built with boards, the slope may be up to 1:33...
-
Will CALGreen be amended to require that some parking spaces are designed so that they can comply with Chapter 11B requirements when converted to EV charging spaces (i.e. slope, vertical clearance, path of travel)?
RESPONSE: DSA is not aware of any efforts to amend the California Green Code in this manner. While the California Green Code nonresidential mandatory measures require projects to...
-
Engineered Wood Fiber
The undulating surface material created changes in level, running and cross slopes exceeding the maximum allowable standards resulting in non-compliant accessible routes to play components...
-
Whitehall Mfg. Ligature Resistant Toilet Top Supply On-Floor
To comply with Ligature-Resistant needs, an optional sloped top cover (box) with a Top Supply flush valve is available....
-
DEL Motorized Solutions Motorized Vertical Shades
This system also has an available option of being mounted in a sloped installation (sizes may vary)....
-
B. What Is a Curb Ramp?
The ramp, or ramp run, is the sloped section that individuals who use wheelchairs travel up and down when transitioning between the street and the sidewalk. ...
-
Accessible Routes
Technical provisions address the width, slope, and surface of both ground level and elevated accessible routes....
-
Accessible Routes
The accessible route must comply with ADAAG provisions for the location, width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level...
-
Parking Spaces [4.6.3]
A maximum slope of 2% is required in all directions for both the space and access aisle since level surfaces are important for wheelchair transfer to and from vehicles....
-
G. Other types of equipment and furniture
equipment and furniture exists that may provide ready access for individuals with disabilities, including pool chairs that permit individuals who use wheelchairs to enter a pool with a sloped...
-
11B-705.1.2.2.2.2 Two entrance/exit points
Where the turning space has two entrance/exit points other than the sloped ramp segments, detectable warnings shall be 36 inches (914 mm) deep at both entrance/ exit points, as measured...
-
What surface characteristics are required of an accessible route?
Because of the great number of variables that affect the performance of a given walking surface--its slope and cross-slope, its material, texture and finish, the presence of moisture or...
-
206.2.1 Site Arrival Points
(1) Newly constructed or altered streets, roads, and highways must contain curb ramps or other sloped areas at any intersection having curbs or other barriers to entry from a street...
-
Alterations to Existing Facilities
For example, if a new bench is installed on a sidewalk that has a cross slope exceeding 2 percent, the sidewalk is not required to be altered to reduce the cross slope because the bench...
-
Trailhead Signs
Length of the trail Type of surface on the trail Typical and minimum trail tread width Typical and maximum trail grade Typical and maximum trail cross slope...
-
Manual vs. Power (RMS Values)
The different slopes of the linear trend lines show that manual WCs will have a greater increase in vibrations for a particular increase in surface roughness than power WCs....
-
Future Work
It will also be able to determine other surface characteristics such as cross-slope, running slope, and instantaneous height changes which have limits already established in the ADAAG....
