High efficiency ultra low consumption (1.1gpf/4.2Lpf), utilizes 31% less water Meets EPA WaterSense® criteria Combination bowl and tank, less seat 12" (305mm) rough...
Search Results "Seat Height"
-
American Standard Cadet 1.1 gpf FloWise Right Height Pressure Assisted Elongated Toilet 2467100
-
608.3.2 Standard Roll-In Type Shower Compartments
Where a seat is provided in standard roll-in type shower compartments, grab bars shall be provided on the back wall and the side wall opposite the seat....
-
608.3.2 Standard Roll-In Type Shower Compartments
Where a seat is provided in standard roll-in type shower compartments, grab bars shall be provided on the back wall and the side wall opposite the seat....
-
5.3.3.2 Location Where Walls Provided
Where walls or partitions are provided, the seat shall be positioned with a wall or partition to the rear and to one side of the seat for a left-hand or right-hand approach. ...
-
Group ticket sales. (Section-by-Section Analysis)
The purpose of the proposed rule is to prevent the current practice of separating groups in a way that isolates or segregates those in the group who require wheelchair seating. ...
-
Group ticket sales. (Section-by-Section Analysis)
If a group includes one or more individuals who use a wheelchair, the proposed rule requires the facility to place that group in a seating area that includes wheelchair spaces so that, if...
-
§ 36.302(f)(1)(i)
(i) For the purposes of this section, “accessible seating” is defined as wheelchair spaces and companion seats that comply with sections 221 and 802 of the 2010 Standards along with any...
-
American Standard Yorkville 1.1 gpf FloWise Right Height Elongated Pressure Assisted Toilet
efficiency ultra low consumption (1.1gpf/4.2Lpf), utilizes 31% less water Meets EPA WaterSense® criteria Floor-mounted, back-outlet toilet combination bowl and tank less seat...
-
11B-226.1 General
Where dining surfaces are provided for the consumption of food or drink, at least 5 percent of the seating spaces and standing spaces at the dining surfaces shall comply with Section 11B...
-
§ 36.302(f)(1) General
A public accommodation shall modify its policies, practices, or procedures to ensure that individuals with disabilities can purchase tickets for accessible seating during the same hours,...
-
§ 36.302(f)(3) Ticket prices
The price of tickets for accessible seating for a single event or series of events shall not be set higher than the price for other tickets in the same seating section for the same event...
-
703.4.1 Height Above Finish Floor or Ground
Tactile characters on signs shall be located 48 inches (1220 mm) minimum above the finish floor or ground surface, measured from the baseline of the lowest tactile character and 60...
-
5.2.2.1 Transfer Surface Width Recommendations for M302
Width Recommendations for M302 The Committee recommends 21 inches for the minimum width of the transfer surface of examination chairs and other equipment primarily used by patients in a seated...
-
Figure 1009.2.2 Pool Lift Seat Location – Drawing from the U.S. Access Board
-
703.4 Installation Height and Location
Signs with tactile characters shall comply with 703.4.
-
703.4 Installation Height and Location
Signs with tactile characters shall comply with 703.4.
-
5.5.1 Armrest Provision for M302
5.5.1 Armrest Provision for M302 Description: Diagnostic equipment used by patients in a seated position such as exam chairs typically have armrests....
-
11B-809.10.8.1 Location
Lavatories without base cabinets shall be installed with the centerline 18 inches (457 mm) minimum from an adjoining wall or fixture to allow for forward approach. Lavatories with...
-
11B-809.10.8.1 Location
Lavatories without base cabinets shall be installed with the centerline 18 inches (457 mm) minimum from an adjoining wall or fixture to allow for forward approach. Lavatories with...
-
American Standard Cadet 1.1 gpf FloWise Right Height Pressure Assisted Elongated Toilet 2467136
High efficiency ultra low consumption (1.1gpf/4.2Lpf), utilizes 31% less water Meets EPA WaterSense® criteria Combination bowl and tank, less seat 12" (305mm) rough...
-
5.1 GENERAL
In addition to the requirements of 4.1 to 4.33, the design of at least 5 percent of all fixed seating or tables in a restaurant or cafeteria shall comply with 4.32....
-
M301.2.1 Transfer Surface Height
M301.2.1 Transfer Surface Height Subcommittee Recommendation: The imaging subcommittee decided to not specifically come up with a recommendation for transfer height, rather leaving...
-
General: ADA Standard Section 226.1
Section 226.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for dining surfaces and work surfaces.
-
Four Specific Situations in which a Seating Accommodation Must be Provided
you must provide a particular seating accommodation, if requested....
