If a bank provides both interior and exterior ATMs, each such installation is considered a separate location....
Search Results "Military Installation"
-
220.1 General
-
206.7.5 Existing Site Constraints
While the site constraint must reflect exterior conditions, the lift can be installed in the interior of a building....
-
226.1 General
However, employers should consider work surfaces that are flexible and permit installation at variable heights and clearances....
-
Example: Town Meeting
The town council considers installing an elevator in the building as well as replacing the existing town hall with a new, fully accessible building, but determines that the town’s limited...
-
Detectable Warnings [4.7.7]
Jurisdictions may continue to install the truncated domes specified in ADAAG or other surfaces or technologies if they wish but are not obligated to do so....
-
2.1.2.3 New York State Standards
2.1.2.3 New York State Standards Ambient electro-magnetic fields should not exceed 30 mA/meter; higher levels would preclude the installation of an IL in the particular location....
-
A4.5.3 CARPET
Firm carpeting can be achieved through proper selection and combination of pad and carpet, sometimes with the elimination of the pad or cushion, and with proper installation....
-
9.2* POST OFFICE LOBBIES
(1) All fixed partitions must be installed to withstand a 250-pound force applied at any point and from any direction....
-
Clear Width [§405.5]
must comply except that: the clear width can be reduced below 36” by work area equipment where it is essential to the work being performed (§405.5); and handrails can be installed...
-
11B-904.6 Security glazing
Where assistive listening devices are installed, place signs complying with Section 11B-703.7.2.4 to identify those facilities which are so equipped....
-
ASME: ADA Standard Section 105.2.2
Section 105.2.2 of the ADA Standards cover references to the American Society of Mechanical Engineers (ASME) standards.
- Doug Mockett & Company SDH1 Sliding Door Hardware
- Open Future Learning
-
206.7.5 Existing Site Constraints
While the site constraint must reflect exterior conditions, the lift can be installed in the interior of a building....
-
702.1 General
Fire alarm systems shall have permanently installed audible and visible alarms complying with NFPA 72 (1999 or 2002 edition) (incorporated by reference, see "Referenced Standards" in Chapter...
-
11B-217.4 TTYs
However, the requirement for at least one TTY on an exterior site cannot be met by installing a TTY in a bank inside a building....
-
608.5.2 Standard Roll-In Type Shower Compartments
Where a seat is provided, the controls, faucets, and shower spray unit shall be installed on the back wall adjacent to the seat wall and shall be located 27 inches (685 mm) maximum from...
-
H. How Can You Tell if a Curb Ramp is Accessible?
To assist you, the next installment of this Tool Kit will include instructions on how to survey curb ramps for compliance with the ADA Standards and a Curb Ramps survey form for use in conducting...
-
11B-308.3.1 Unobstructed
Operable parts of fuel dispensers shall be permitted to be 54 inches (1372 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
11B-206.7.5 Existing site constraints
While the site constraint must reflect exterior conditions, the lift can be installed in the interior of a building....
-
608.5.3 Alternate Roll-In Type Shower Compartments
Where a seat is not provided, the controls, faucets, and shower spray unit shall be installed on the side wall farthest from the compartment entry....
-
608.5.2 Standard Roll-In Type Shower Compartments
Where a seat is provided, the controls, faucets, and shower spray unit shall be installed on the back wall adjacent to the seat wall and shall be located 27 inches (685 mm) maximum from...
-
702.1 General
Fire alarm systems shall have permanently installed audible and visible alarms complying with NFPA 72 (1999 or 2002 edition) (incorporated by reference, see “Referenced Standards” in Chapter...
-
806.3 Guest Rooms with Communication Features
For headset or external amplification system compatibility, a standard subminiature jack installed in the telephone will provide the most flexibility....
