We support local, regional, and long-distance trails and greenways, whether they be in backcountry, rural or urban areas....
Search Results "Travel Distance"
- American Trails Resources and Library: Accessible Trails
- EZ-ACCESS Transitions® Modular Entry Ramp
- Otis Elevator HANDSOFF Phone
- SafePath EntryLevel™ Landings
- Direct Access Solutions Kit
-
Transfer Supports Location and Configuration M301.3 and M302.3
The length of the transfer support shall be a minimum of 15 inches long and positioned so that the transfer support overlaps the length of the transfer surface by 80% at a maximum distance...
-
1002.5 Amusement Ride Seats Designed for Transfer
Where greater distances are required for transfers, providing gripping surfaces, seat padding, and avoiding sharp objects in the path of transfer will facilitate the transfer....
-
B) Accessible Route
The width of an accessible route can be as narrow as 32 inches wide, such as at a doorway or a narrow section of hallway, but only for a distance up to 24 inches long....
-
407.3.4 Door and Signal Timing
car start to close shall be calculated from the following equation: T = D/(1.5 ft/s) or T = D/(455 mm/s) = 5 seconds minimum where T equals the total time in seconds and D equals the distance...
-
11B-216.3 Directional and informational signs
It should be noted that exterior signs are likely to be viewed at a greater distance than interior signs, which would affect the prescribed height of visual characters....
-
Verify Framing
11B-402 Door opening widths. 11B-404 Maneuvering clearances/landings at doors. 11B-404 Distance...
-
4.1.2(5)(a)
They may be provided in a different location if equivalent or greater accessibility, in terms of distance from an accessible entrance, cost and convenience is ensured....
-
Verify Framing
11B-402 Door opening widths. 11B-404 Maneuvering clearances/landings at doors. 11B-404 Distance...
-
Jogging Strollers
Jogging Strollers In recent years, large-wheeled jogging strollers have become increasingly popular, especially for longer distance use on paths and roads (figure 3)....
-
Turning Space [§304]
Turning space is recommended in small spaces with entrapment risks as well as at dead-end aisles and corridors so that people using wheeled mobility aids do not have to back up considerable distances...
-
11B-216.3 Directional and informational signs
It should be noted that exterior signs are likely to be viewed at a greater distance than interior signs, which would affect the prescribed height of visual characters. ...
-
11B-216.3 Directional and informational signs
It should be noted that exterior signs are likely to be viewed at a greater distance than interior signs, which would affect the prescribed height of visual characters....
-
What do I do if a passenger claims that he or she is allergic to someone else’s service animal?
or respiratory distress that could require emergency or significant medical treatment), and there is a service animal of that kind seated nearby, the carrier should try to place as much distance...
-
Raised and Brailled Characters and Pictorial Symbol Signs [4.30.4]
Recommended Braille Specifications nominal height 0.019 in nominal base diameter 0.057 in nominal distance (center to center) of adjacent dots...
-
Which transition type do users with disabilities prefer?
When a sidewalk slopes more than 2% in the direction of travel and a walk with a maximum 2% cross slope intersects it, which transition segment type provides the safest usability for the...
-
Where must curb ramps be provided?
Curb ramps must be located to ensure a person with a mobility disability can travel from a sidewalk on one side of the street, over or through any curbs or traffic islands, to the sidewalk...
-
Other Federal Disability Rights Laws
There are other Federal disability rights laws that cover housing, air travel, telecommunications, Federal programs and services, and other topics....
-
5. CONSTRUCTION TOLERANCES
While it is always advisable to avoid design requirements that are at or near dimensional thresholds, construction tolerances may be used when evaluating the compliance of existing path of travel...
-
Openings [1017.6]
Where possible, elongated openings should be placed perpendicular, or as close to perpendicular as possible, to the dominant direction of travel....