[See subsections ...]
Search Results "Transfer Surface Height"
-
11B-226 Dining surfaces and work surfaces
-
1008.3.1.1 Size
Transfer platforms shall have level surfaces 14 inches (355 mm) deep minimum and 24 inches (610 mm) wide minimum....
-
1008.3.2.1 Size
Transfer steps shall have level surfaces 14 inches (355 mm) deep minimum and 24 inches (610 mm) wide minimum....
- Envirobond is Self-Healing
- Organic-Lock: The Self-Healing Organic Binder
- Envirobond Deters Weeds
-
Carpet [§302.2]
The standards specify the maximum pile height (1/2” measured to the backing, cushion, or pad) and texture (level or textured loop, level cut pile, or level cut/uncut pile) and require firm...
-
11B-302.2 Carpet
Pile height shall be ½ inch (12.7 mm) maximum. Exposed edges of carpet shall be fastened to floor surfaces and shall have trim on the entire length of the exposed edge....
-
11B-302.2 Carpet
Pile height shall be ½ inch (12.7 mm) maximum. Exposed edges of carpet shall be fastened to floor surfaces and shall have trim on the entire length of the exposed edge....
-
11B-405.3 Cross slope
Cross slope is the slope of the surface perpendicular to the direction of travel....
-
11B-405.3 Cross slope
Cross slope is the slope of the surface perpendicular to the direction of travel....
-
9. When ramp access is provided to one side of a crawl tube and the other side is only entered by transfer access, how is it counted (ramp or transfer access play component)?
When ramp access is provided to one side of a crawl tube and the other side is only entered by transfer access, how is it counted (ramp or transfer access play component)?...
- Cargill, Incorporated SafeLane® Surface Overlay CA-48
-
1014.3 Floor
This section requires the floor surface within camp shelters to be firm and stable and to slope not steeper than 1:48 in any direction....
-
Installation of Test Surfaces
Installation of Test Surfaces In accordance with standard EWF design and construction practice (Figure 2), the full depth surfaces were prepared to the same requirements needed for permanent...
- Figure 1008.3.1 Transfer Platforms – Drawing from the U.S. Access Board
-
Installation of Aggregate Surfaces at Bradford Woods
Installation of Aggregate Surfaces at Bradford Woods The installation of the aggregate surfaces at Bradford Woods conformed to the following protocol: Prior to installing the crushed...
-
4.30.3 Character Height
The minimum height is measured using an upper case X. Lower case characters are permitted....
-
BACKGROUND
Transfer supports and their connections shall be capable of resisting vertical and horizontal forces of 250 pounds (1,112 N) applied at all points on the transfer support....
-
A4.5.1 GENERAL
Wheelchairs can be propelled most easily on surfaces that are hard, stable, and regular....
-
Findings
The following are the predominant findings from this study: No single type of surface material/system was found to be the most accessible surface or better than others when comparing...
- Playworld® SMARTE Safety Surfacing
-
703.5.6 Height From Finish Floor or Ground
Visual characters shall be 40 inches (1015 mm) minimum above the finish floor or ground. EXCEPTION: Visual characters indicating elevator car controls shall not be required to...
-
7. Lavatory
7. Is the lavatory (wash basin) in each accessible guestroom bathroom no more than 34" high with at least 29" high clearance under the front edge to allow persons who use wheelchairs...