Guestroom Doors Common Problem: Doors and doorways into and within all guestrooms and suites, including bathroom doors and doorways, do not allow 32 inches of clear opening width....
Search Results "Elevator Car Door"
Commonly Searched Documents
-
Guestroom Doors
-
407.2.1.5 Signals
Destination-oriented elevators shall not be required to comply with 407.2.1.5 provided that visible and audible signals complying with 407.2.2 indicating which elevator car to enter are...
-
11B-604.8.1.1.3 Maneuvering space with end-opening door
In a wheelchair accessible compartment with a door located in the front wall or partition (facing the water closet), either in-swinging or out-swinging, a minimum 60 inches (1524 mm) wide...
-
11B-604.8.1.1.3 Maneuvering space with end-opening door
11B-604.8.1.1.3 Maneuvering space with end-opening door....
-
Elevators
Elevators: c....
-
§ 38.125(b)(2)(ii) Exception
Where physical or safety constraints prevent the deployment at some stops of a lift having its long dimension perpendicular to the car axis, the transportation entity may specify a lift...
-
Closers
Closers Automated door closing is addressed by the ANSI/BHMA standards....
-
D3. Door Hardware
Is the door hardware (e.g., lever, pull, panic bar) usable with one hand without tight grasping, pinching, or twisting of the wrist?...
-
Ground Level and Elevated Play Components: ADA Standard Section 1008.2.1
Transfer systems complying with 1008.3 shall be permitted to connect elevated play components except where 20 or more elevated play components are provided no more than 25 percent of the...
-
11B-404.2.10 Door and gate surfaces
Swinging door and gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
11B-404.2.10 Door and gate surfaces
Swinging door and gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
11B-404.2.10 Door and gate surfaces
Swinging door and gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
§ 38.111(a)(1)
(1) Single-level rail passenger coaches and food service cars (other than single-level dining cars) shall comply with §§38.113 through 38.123 of this part....
-
G. Door Hardware
Is the door hardware (levers, pulls, panic bars, etc.) on all entry doors to accessible guestrooms and other passage doors within the room usable with one hand, without tight grasping, pinching...
-
Hall Lanterns [4.10.4]
At least one visible signal must serve each car. A separate fixture for each direction is not required; two-stop elevator cars can be served by one fixture that indicates car arrival....
-
A. Entry Doors
Do entry doors, connecting room doors, and interior doors (except doors to shallow closets) into and within all guestrooms and suites allow 32" clear passage width so persons who use wheelchairs...
-
Lifts and Elevators
If the voting area is not on the same level as the entrance, there must be an independently operable elevator or lift to provide an accessible route to individuals with disabilities....
-
11B-408.2 Elevator landings
Landings serving limited-use/limited-application elevators shall comply with Section 11B-408.2....
-
11B-408.2 Elevator landings
Landings serving limited-use/limited-application elevators shall comply with Section 11B-408.2....
-
11B-408.2 Elevator landings
Landings serving limited-use/limited-application elevators shall comply with Section 11B-408.2....
-
11B-411.2.3 Signs on jambs of elevator hoistway entrances
Signs on jambs of elevator hoistway entrances shall comply with Section 11B-411.2.3....
-
11B-411.2.3 Signs on jambs of elevator hoistway entrances
Signs on jambs of elevator hoistway entrances shall comply with Section 11B-411.2.3....
-
11B-411.2.3 Signs on jambs of elevator hoistway entrances
Signs on jambs of elevator hoistway entrances shall comply with Section 11B-411.2.3....