Characters shall be selected from fonts where the width of the uppercase letter “O” is 55 percent minimum and 110 percent maximum of the height of the uppercase letter “I”....
Search Results "Coin Slot Height"
Filters
Commonly Searched Documents
-
Character Proportions: ADA Standard Section 703.5.4
-
11B-812.7.3 Lettering
The words “NO PARKING” shall be painted on the surface within each access aisle in letters a minimum of 12 inches (305 mm) in height and located to be visible from the adjacent vehicular...
-
Front grab bar protocol
Adjustable height protocol). ...
-
Quantum Single Load Dryer Front Control by Speed Queen
This dryer is available with the following activation types: Card Ready and Coin Drop Features Industry's Largest Door Opening 2.06 sq. ft. (1914 cm²)....
-
11B-608.3 Grab bars
Where multiple grab bars are used, required horizontal grab bars shall be installed at the same height above the finish floor....
-
11B-225.2.3 Library book stacks
ETA Editor's Note The ADA Advisory identifies library shelving as self-service shelving, which does not have a height limitation....
-
604.7 Open Type Toilet Paper Dispenser Height
-
902.3 Baby Changing Table Work Surface Height
-
Character Spacing: ADA Standard Section 703.5.8
Spacing between individual characters shall be 10 percent minimum and 35 percent maximum of character height....
-
11B-703.5.8 Character spacing
Spacing between individual characters shall be 10 percent minimum and 35 percent maximum of character height....
-
Pilot Rock N-20 Series Charcoal Grill
Video showing adjustable heights of Pilot Rock N-20 Series Charcoal Grill. ...
-
Single Occupant Structures: ADA Standard Section 203.6
Section 203.6 covers scoping requirements of general exceptions for single occupant structures in the most current ADA Standards.
-
11B-203.6 Single occupant structures
Single occupant structures accessed only by passageways below grade or elevated above standard curb height, including but not limited to, toll booths that are accessed only by underground...
-
11B-411.2.2.1 Visible identification
The characters on the fixture shall be upper case with a height of 4 inches (102 mm) minimum complying with Sections 11B-703.5.1, 11B-703.5.3, 11B-703.5.4, 11B-703.5.7 and 11B-703.5.8....
-
Speed Queen Quantum Single Load Dryer Front Control Stainless Steel Cabinet
This Dryer is available with the following activation types: Card Ready and Coin Drop. Features Industry's Largest Door Opening 2.06 sq. ft. (1914 cm²)....
-
Water Closets and Toilet Compartments for Children's Use: ADA Standard Section 604.9
Section 604.9 covers the current ADA Standards for water closets and toilet compartments for children's use.
-
Aluminum Dove Tail Series Pressure-Locked Grating
ADT Series Traditionally designed, Aluminum Dove Tail (ADT) slot pressure locked grating offers a smooth, clean line of a flush top rectangular cross bar....
-
Grab bar protocol
to a lower height when using the bar, and the bar height preference was 30 ± 3.9” (76.2±9.9cm) median 30” (76.2cm)....
-
Clearance Reduction: ADA Standard Section 306.3.4
Section 306.3.4 covers the current ADA Standards for knee clearance width reduction.
-
Tork Elevation® Matic® Hand Towel Roll Dispenser with Intuition® Sensor, Black
Numerous back-plate mounting slots fit most any pattern. Utilizes any Tork H1 Roll Towel. Uses 3 "D size" batteries. Replaces 309609A. Also available in White 5511201....
-
PUBLIC WAY
of land open to the outside air leading to a street, that has been deeded, dedicated or otherwise permanently appropriated to the public for public use and which has a clear width and height...
-
CURRENT SITUATION: THE VAST MAJORITY OF EXAMINATION AND PROCEDURES TABLES ARE 32 INCHES HIGH
Figure 1: Percentage of fixed height versus adjustable height medical tables (representing the U.S. install base of medical tables) One of the primary objectives of the U.S....
-
Elevator Car Controls
Comments recommended that the height of elevator car controls be harmonized with the ANSI A117.1 standard....
-
Side guard protocol
Side guard protocol: From initial setup, two side guards adjusted 6” (15.2 cm) higher than the subject’s WMD seat were attached, and subjects were asked to perform a level height transfer...
