A public or common use area that complies with the appropriate requirements of ICC/ANSI A117.1-2003 (incorporated by reference at §100.201a), ICC/ANSI A117.1-1998 (incorporated by reference...
Search Results "ANSI: American National Standards Institute"
Commonly Searched Documents
-
§100.201 Accessible
-
608.5.2 Standard Roll-In Type Shower Compartments
In standard roll-in type shower compartments, the controls, faucets, and shower spray unit shall be located above the grab bar, but no higher than 48 inches (1220 mm) above the shower floor...
-
b) Historic Curb Ramp Design Standards
b) Historic Curb Ramp Design Standards 72....
-
Stairway Handrails Requirements in the ADA Standards (§504)
Stairway Handrails Requirements in the ADA Standards (§504) Protruding Objects The ADA Standards address hazards posed by protruding objects, such as standpipe valves, along...
-
Small entities potentially affected by proposed standards
The proposed standards do not impose any mandatory requirements on health care providers or medical device manufacturers....
-
(3) the City's curb ramp design standard
(3) the City's curb ramp design standard utilized between 1994 and 2004 pursuant to which it constructed curb ramps with a V inch lip at the base in violation of federal disability access...
- Disability Access Consultants (DAC) Corp.
- Sargent 8200 Mortise Lock with BHL Trim
-
§1607.14 Technical standards for validity studies.
The following minimum standards, as applicable, should be met in conducting a validity study....
-
2.4.2 Considerations of Manufacturers in Accessible MDE Design
As detailed in Section 2.5.2.1, the most common standard used by manufacturers to guide the design of medical equipment is ANSI/AAMI ES60601-1:2005K, which is the U.S. version of the larger...
-
608.3.2 Standard Roll-In Type Shower Compartments
Where a seat is provided in standard roll-in type shower compartments, grab bars shall be provided on the back wall and the side wall opposite the seat....
-
Guidelines for Requirement 2
The Department has retained the applicable provisions of the ANSI Standard for parking space....
-
8. Revisions to Exceptions under 508 Standards
There is no general rule in the existing 508 Standards that agencies provide assistive technology at all employee workstations; rather, these standards merely require compatibility with...
-
608.5.2 Standard Roll-In Type Shower Compartments
In standard roll-in type shower compartments, the controls, faucets, and shower spray unit shall be located above the grab bar, but no higher than 48 inches (1220 mm) above the shower floor...
-
Americans with Disabilities Compliance Clause for the Group
The “Group” refers to the individual, organization or company contracting with the venue for the meeting, conference or event. The venue may require a clause that specifies the...
-
§100.201 Accessible route
A route that complies with the appropriate requirements of ICC/ANSI A117.1-2003 (incorporated by reference at §100.201a), ICC/ANSI A117.1-1998 (incorporated by reference at §100.201a), CABO...
-
ADDITIONAL INFORMATION ABOUT THE 2010 STANDARDS
ADDITIONAL INFORMATION ABOUT THE 2010 STANDARDS 18. What is the Department's approach going to be to ensuring compliance with the new regulation pertaining to pool lifts?...
-
608.2.2 Standard Roll-In Type Shower Compartments
608.2.2 Standard Roll-In Type Shower Compartments....
- American Foundation for the Blind® Support, Programs and Services
-
36 CFR Part 1192 Americans with Disabilities Act (ADA) Accessibility Guidelines for Transportation Vehicles (2016 Non-Rail Vehicle Guidelines)
Department of Transportation (DOT) is required to revise its accessibility standards for transportation vehicles acquired or remanufactured by entities covered by the Americans with Disabilities...
-
36 CFR Part 1194 Electronic and Information Technology Accessibility Standards (Section 508 Standards)
36 CFR Part 1194 Electronic and Information Technology Accessibility Standards [Docket No. 2000–01] RIN 3014–AA25 AGENCY: Architectural and Transportation Barriers Compliance Board...
-
E103.4 508 Standards (Section-by-Section Analysis)
The term “508 Standards” is defined in order to provide consistent cross-reference within the standards to all chapters that apply to Section 508-covered federal entities, namely: 508 Chapters...
- Corbin Russwin Inc. BLSS Trim Lever Handle & Lockset
-
Department of Housing and Urban Development under the Fair Housing Act
for residential facilities contained in the ANSI A117.1 standard....