An accessible route complying with Division 4 shall be provided to the ground- or floor-level entry points, where provided, of stairs, ladders, or other means of reaching the raised elements...
Search Results "Character Proportion (Raised)"
Commonly Searched Documents
-
11B-203.11 Water slides
-
Sloped Surfaces
The amount of slope or grade is described as the proportion of a vertical rise to a horizontal length....
-
4.4.1 Overview of Mammography Accessibility Considerations
Since breast platform design affects most of the other device components, defining each component in relationship to the breast platform creates proportions that, when incorporated into...
-
Circulation and flow
., N.W. does not have directional signage to the exterior accessible Café entrance and the characters of the signage on the accessible Café entry door on 9th St., N.W. do not contrast with...
-
§ 37.107(c)
(c) Compliance with paragraph (b) of this section is not required to the extent that it would significantly alter the historic or antiquated character of a historic or antiquated rail passenger...
-
11B-705.2 Detectable directional texture
Detectable directional texture at transit boarding platforms shall comply with Figure 11B-705.2 and shall be 0.1 inch (2.5 mm) in height that tapers off to 0.04 inch (1.0 mm), with bars raised...
-
1009.2.6 Footrests and Armrests
If provided, the armrest positioned opposite the water shall be removable or shall fold clear of the seat when the seat is in the raised (load) position....
-
1009.2.4 Seat Height
height of the lift seat shall be designed to allow a stop at 16 inches (405 mm) minimum to 19 inches (485 mm) maximum measured from the deck to the top of the seat surface when in the raised...
-
Floor Height [1013.4]
If the tent platform floor is raised above grade, the floor height must be no more than 19 inches when measured from the clear ground space to the tent platform surface....
-
12. Portray successful people with disabilities in a balanced way, not as heroic or superhuman.
Stereotypes may raise false expectations that everyone with a disability is or should be an inspiration. People may be inspired by them just as they may be inspired by anyone else....
-
11B-203.11 Water slides
An accessible route complying with Division 4 shall be provided to the ground- or floor-level entry points, where provided, of stairs, ladders or other means of reaching the raised elements...
- Cybex Total Access Treadmill
- Armedica Hi Lo Adult Changing Table from MAX-Ability
-
Floor Designations
The proposed rule specified that tactile floor designations at the hoistway be 60 inches above the floor, measured from the baseline of the characters (407.2.4)....
-
11B-703.6.1 Pictogram field
Characters and Braille shall not be located in the pictogram field. Advisory 11B-703.6.1 Pictogram field....
-
§8.56(e)(1)(ii)
or recipient complained against of the allegations and give the applicant or recipient an opportunity to make a written submission responding to, rebutting, or denying the allegations raised...
-
4.13.8* Thresholds at Doorways
Raised thresholds and floor level changes at accessible doorways shall be beveled with a slope no greater than 1:2 (see 4.5.2)....
-
R305.2.3 Blended Transitions
Where raised pedestrian street crossings, depressed corners, or other level pedestrian street crossings are provided, detectable warning surfaces shall be placed at the flush transition...
-
4.13.8* THRESHOLDS AT DOORWAYS
Raised thresholds and floor level changes at accessible doorways shall be beveled with a slope no greater than 1:2 (see 4.5.2)....
-
§ 38.161 Moveable aisle armrests
A minimum of 50% of aisle seats, including all moveable or removable seats at wheelchair or mobility aide securement locations, shall have an armrest on the aisle side which can be raised...
-
Issue 10: Braille (right side up?)
Remedy: Braille is made up of small dots in a grid which are raised on the surface to be read by fingertip....
-
CONCLUSION
CONCLUSION Defendants’ raised porches violate both the letter and the spirit of the ADA. ...
-
11B-411.2.1.5.1 Size
Buttons shall have square shoulders, be 3/4 inch (19.1 mm) minimum in the smallest dimension and shall be raised 1/8 inch (3.2 mm) plus or minus 1/32 inch (0.8 mm) above the surrounding...