R216 Stairways and Escalators (Section-by-Section Analysis) Stairways on pedestrian circulation paths must comply with technical requirements for stairways in Chapter R4....
Search Results "Circular Cross Section"
-
R216 Stairways and Escalators (Section-by-Section Analysis)
-
Section 206.3
Section 206.3 This section concerns the location of accessible paths....
-
Definition of "wheelchair.'' (Section-by-Section Analysis)
In seeking public feedback on the NPRM's definition of ‘‘wheelchair,'' the Department explained its concern that the definition of ‘‘wheelchair'' in section 508(c)(2) of the ADA (formerly...
-
410.7 Caller ID (Section-by-Section Analysis)
410.7 Caller ID (Section-by-Section Analysis) This section proposes that, where ICT provides two-way voice communication, any associated caller identification or similar telecommunications...
-
Dispersion of cells. (Section-by-Section Analysis)
inaccessible cells, even though accessible cells were available elsewhere in the facility, because there were no cells in the areas where they needed to be housed, such as the women's section...
-
Section 36.304 Removal of Barriers (Section-by-Section Analysis)
Section 36.304 Removal of Barriers (Section-by-Section Analysis) With the adoption of the 2010 Standards, an important issue that the Department must address is the effect that the new...
-
M301.2 Transfer Surface (Section-by-Section Analysis)
This is an introductory section....
-
M302.2 Transfer Surface (Section-by-Section Analysis)
This is an introductory section....
-
M303.2 Wheelchair spaces (Section-by-Section Analysis)
This is an introductory section....
-
§35.163 Information and Signage (Section-by-Section Analysis)
§35.163 Information and Signage (Section-by-Section Analysis) Section 35.163(a) requires the public entity to provide information to individuals with disabilities concerning accessible...
-
407.6 Status Indicators (Section-by-Section Analysis)
407.6 Status Indicators (Section-by-Section Analysis) This section would require status indicators, including all locking or toggle controls or keys, such as “Caps Lock” and “Num Lock...
-
Alterations to stairs (Section-by-Section Analysis)
In contrast, section 210.1 of the 2010 Standards requires all newly constructed stairs that are part of a means of egress to be accessible....
-
§35.131(c) (Section-by-Section Analysis)
This paragraph implements the provision in section 510(b) of the Act that allows entities "to adopt or administer reasonable policies or procedures, including but not limited to drug testing...
-
Alterations to stairs. (Section-by-Section Analysis)
In contrast, section 210.1 of the 2010 Standards requires all newly constructed stairs that are part of a means of egress to be accessible....
-
E202.6.1 Required Documentation (Section-by-Section Analysis)
E202.6.1 Required Documentation (Section-by-Section Analysis) This section proposes to require that agencies document in writing the basis for determining that ICT fully conforming to...
-
SECTION#4
SECTION#4 For the following questions, please answer every item pertaining to the sub-base installation, if the sub-base installation was necessary due to the installation of the trail...
-
Turning Space: ADA Standard Section 1010.1
A circular turning space 60 inches (1525 mm) diameter minimum with slopes not steeper than 1:48 shall be provided at shooting facilities with firing positions....
-
M305.2 Transfer Supports (Section-by-Section Analysis)
This is an introductory section. As discussed above in Section IV.E.1....
-
Passing Spaces (R302.4) (Section-by-Section Analysis)
Passing Spaces (R302.4) (Section-by-Section Analysis) Where the clear width of pedestrian access routes is less than 1.5 meters (5 feet), passing spaces must be provided at intervals...
-
Detectable Warning Surfaces on Curb Ramps (Section-by-Section Analysis)
Detectable Warning Surfaces on Curb Ramps (Section-by-Section Analysis) When the Access Board issued the 1991 ADAAG, the guidelines contained a requirement for detectable warning surfaces...
-
11B-1010.1 Turning space
A circular turning space 60 inches (1524 mm) diameter minimum with slopes not steeper than 1:48 shall be provided at shooting facilities with firing positions....
-
11B-1010.1 Turning space
A circular turning space 60 inches (1524 mm) diameter minimum with slopes not steeper than 1:48 shall be provided at shooting facilities with firing positions....
-
Number of accessible cells. (Section-by-Section Analysis)
Section 232.2.1 of the 2004 ADAAG requires at least two percent (2%), but no fewer than one, of the cells in newly constructed detention and correctional facilities to have accessibility...
-
502.3.1 Object Information (Section-by-Section Analysis)
502.3.1 Object Information (Section-by-Section Analysis) This section proposes that particular programming elements—namely object role, state, boundary, name, and description—must be...