[See subsections ...]
Search Results "Wet Bar"
-
1607.8 Loads on handrails, guards, grab bars shower seats, dressing room bench seats and seats
-
11B-705.2 Detectable directional texture
Detectable directional texture at transit boarding platforms shall comply with Figure 11B-705.2 and shall be 0.1 inch (2.5 mm) in height that tapers off to 0.04 inch (1.0 mm) , with bars...
-
604.7 Dispensers
The outlet of the dispenser shall be 15 inches (380 mm) minimum and 48 inches (1220 mm) maximum above the finish floor and shall not be located behind grab bars....
-
608.6 Shower Spray Unit and Water
If an adjustable-height shower head on a vertical bar is used, the bar shall be installed so as not to obstruct the use of grab bars....
-
608.6 Shower Spray Unit and Water
If an adjustable-height shower head on a vertical bar is used, the bar shall be installed so as not to obstruct the use of grab bars....
-
11B-705.2 Detectable directional texture
Detectable directional texture at transit boarding platforms shall comply with Figure 11B-705.2 and shall be 0.1 inch (2.5 mm) in height that tapers off to 0.04 inch (1.0 mm) , with bars...
-
Types of Alternative Designs
The positioning and type of grab bars were also changed to provide more room and flexibility....
-
406 Curb Ramps
These include specifications for running slope, surface, clear width, and wet conditions. Consistent with the scope of the guidelines, these requirements apply to facilities on sites....
-
Just Manufacturing Classroom Concealed Ledgemount Teardrop Handles Restricted Swing Faucet
Classroom faucets feature rigid spouts, or restricted swing spouts, providing preventative measures against wet counter tops in the classroom....
-
Just Manufacturing Concealed Classroom Faucet with High Rise Spout
Classroom faucets feature rigid spouts, or restricted swing spouts, providing preventative measures against wet counter tops in the classroom....
-
604 Water Closets and Toilet Compartments
Revisions to the requirements for water closets concern: location (604.2) clearance (604.3) grab bars (604.5) flush controls (604.6) dispensers (...
-
Size and Clearances [4.21.2]
The 36 by 36 inch dimension, measured to the interior finish, keeps front and side grab bars within reach from the seat....
-
11B-212.3 Sinks
The ADA requirements and exceptions make no mention of wet bars, scullery sinks or scrub sinks. ...
-
11B-212.3 Sinks
The ADA requirements and exceptions make no mention of wet bars, scullery sinks or scrub sinks. ...
-
Space Needs
11 shows that for a given width of 40 inches (centered in front of the transfer station) that 25% of the subjects were able to perform a transfer to the platform in Protocol A (no grab bars...
-
Envirobond Organic-Lock™ Surface Stabilizer
In addition, this gel creates a thin film on the surface of the joint when wet. This film acts as a buffer zone which water can slide over, preventing washouts....
-
608.6 Shower Spray Unit and Water
If an adjustable-height shower head on a vertical bar is used, the bar shall be installed so as not to obstruct the use of grab bars....
-
608.6 Shower Spray Unit and Water
If an adjustable-height shower head on a vertical bar is used, the bar shall be installed so as not to obstruct the use of grab bars....
-
E. Restaurants and Concessions:
PSE shall continue to provide accessible tables, marked with the International Symbol for Accessibility, within the bar areas of the Red Bull Bar and Captain Morgan's Bar located in the...
-
1132A.8 Hand-activated door hardware
Latching and locking doors that are hand-activated and on an accessible route shall be operable with a single effort by lever-type hardware, panic bars, push-pull activating bars or other...
-
Standard Roll-In Type Shower Compartments: ADA Standard Section 608.5.2
Section 608.5.2 covers the current ADA Standards for controls in standard roll-in type shower compartments.
-
Alternate Roll-In Type Shower Compartments: ADA Standard Section 608.5.3
Section 608.5.3 covers the current ADA Standards for controls in alternate roll-in type shower compartments.
-
5.4.6 Transfer Support Gripping Surface Cross Section and Clearances for M301, M302, and M305.2
NPRM Preamble Discussion: The 2010 Standards specify the following dimensions for grab bars to enable individuals with disabilities to firmly grasp the grab bars and support themselves during...
-
Measures and Procedures
The grab bars’ diameter is 1.5” (3.8cm). The space for the legs and feet has a fixed dimension of 14.5” deep by 22.5” wide (36.8x57.2cm)....
