A minimum 18 inch vertical clearance (specified for recessed handrails) may place elements above maximum reach heights....
Search Results "Vertical Alignment"
Commonly Searched Documents
-
Size and Spacing of Grab Bars and Handrails [4.26.2]
-
4.34.3(2)(b) Reach Depth More Than 10 in
Where the reach depth to the operable parts of any control as measured from the vertical plane perpendicular to the edge of the unobstructed clear floor space at the farthest protrusion...
-
Character Height [4.30.3]
Recommendations: Both the horizontal and vertical viewing distance should be considered....
-
Location
Van-accessible parking spaces located in parking garages may be clustered on one floor (to accommodate the 98-inch minimum vertical height requirement)....
-
Location
Van-accessible parking spaces located in parking garages may be clustered on one floor (to accommodate the 98-inch minimum vertical height requirement)....
-
11B-504.5 Nosings
Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from vertical....
-
11B-504.5 Nosings
Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from vertical....
- Landscape Forms Inc. Towne Square Bench Collection
- PEMKO 5" Latching Panic Saddle Threshold No. 2006-P
- PEMKO 4" Latching Panic Saddle Threshold No. 278x224-FGT
- PEMKO 5" Latching Panic Saddle Threshold No. 2006-V
-
Turning Radius
The implications of these results on horizontal alignment are given in the "Discussion" section. Table 19....
-
Section G: Ramps
(§§405.8, 505.4) G9 If the rise of the ramp is greater than 6" and the ramp or landing has a vertical drop-off on either side of the ramp,...
-
11B-703.7.2.6 Toilet and bathing facilities geometric symbols
Where a door is provided the symbol shall be mounted within 1 inch (25 mm) of the vertical centerline of the door....
-
206.3 Location
Additionally, accessible vertical interior circulation must be in the same area as stairs and escalators, not isolated in the back of the facility Note to Reader: The Department of...
-
Dispersion
This includes choice in both vertical and horizontal sections of a seating bowl and may vary by event....
-
Engineered Surfaces
The roughness index is a measurement how much vertical deviation a standard wheel will experience as it travels over these surfaces and will be explained in more detail later on....
-
221 Assembly Areas
Clarification on the location of wheelchairs spaces and companion seats. 221.2.3.2 Vertical Dispersion....
- Proline Drain: Quick Drain USA - Side Waste Outlet Tub to Shower Conversion
-
1010.1.4 Floor elevation
Landings shall be level except for exterior landings, which are permitted to have a slope not to exceed 0.25 unit vertical in 12 units horizontal (2-percent slope)....
- CRL Jackson 1200 Series Push Pad Door Exit Devices
- Lutron Sivoia QS Wireless Shading System
- PEMKO 5" Latching Panic Saddle Threshold No. 2005-V
- PEMKO 5" Latching Panic Saddle Threshold No. 2005-P