Doors at exit passageways, exit discharge, and exit stairways shall be identified by tactile signs complying with 703.1, 703.2, and 703.5. Advisory 216.4.1 Exit Doors....
Search Results "In-Swinging Door"
Filters
Commonly Searched Documents
-
216.4.1 Exit Doors
-
H5
If there is a raised threshold, is it no higher than 3/4 inch at the door and beveled on both sides?...
-
Yale 51 Series Industrial Door Closer
They are ideal for use with aluminum store front doors and frames, yet they also complement wood or metal door installations....
-
1132A.3, Item 6
6. The width of any component in the means of egress system shall not be less than the minimum width required by Section 1005.
-
1132A.3, Item 6
6. The width of any component in the means of egress system shall not be less than the minimum width required by Section 1005.
-
SOSS Door Hardware UltraLatch Demonstration Video
A very new and unique device that replaces doorknobs with the most ergonomic and comfortable lever for openning and closing doors. Physical therapist J.C....
-
Measuring Opening Force
Measuring Opening Force The maximum force pertains to the continuous application of force necessary to fully open a door, not the initial force needed to overcome the inertia of the door...
-
Toilet Rooms South (Briefing Theater)
The force required to push or pull open the men's toilet room door is 10 lbf, which exceeds the maximum allowable door opening force of 5 lbf. See Standards § 4.13.11(2)(b). kk....
-
1132A.4, Item 4
Secondary exterior doors onto decks, patios or balcony surfaces constructed of impervious materials (e.g., concrete, brick, flagstone) may have a maximum change in height from the interior...
-
§ 38.153(c)(1)
(1) Doors shall have a minimum clear width when open of 30 inches (760 mm), measured from the lowest step to a height of at least 48 inches (1220 mm), from which point they may taper to...
-
Allegion LCN 6030 Series Overhead Concealed Door Control
The single lever arm and roller assembly provides smooth, quiet door control and the choice of finishes and track functions meet virtually all architectural requirements....
-
Toilet Rooms North (Celebrity Spies)–Men [sic]
The force required to push or pull open the men's toilet room door is 10 lbf, which exceeds the maximum allowable door opening force of 5 lbf. See Standards § 4.13.11(2)(b). ee....
-
Allegion LCN 3030 Series Overhead Concealed Door Control
LCN 3030 Series The concealed 3030 is designed to mount in a 1 3/4” interior door....
-
Needs Photos or Technical Info
This article is a good start but, really could use some photos to illustrate the text. For example, what is a faucet that is placed out of reach for persons with cognitive...
-
Sargent Wall and Frame Switch Interface for Door Operators
Wall switches are used to interface with door operators or other electromechanical hardware....
-
Figure 404.2.4.2(a) Maneuvering Clearances at Doorways without Doors, Sliding Doors, Gates, and Folding Doors – Drawing from the U.S. Access Board
-
BEA's MS21 Touchless Activation Sensor
Magic Switch Hardwired Touchless Sensor Door Opener MS21H. ...
-
T204.4 Doorways with Steps on Over-the-Road Buses
On over-the-road-buses, doorways with steps shall comply with T502.4.
-
Locks and Security Devices
Locks and Security Devices Permanently fixed portions of locks, including key locks, bolts, card readers, and push-button devices with number codes for general use by building...
-
4.8.4* Landings
Ramps shall have level landings at bottom and top of each ramp and each ramp run. Landings shall have the following features:
-
4.8.4 LANDINGS
Ramps shall have level landings at the bottom and top of each run. Landings shall have the following features: (1) The landing shall be at least as wide as the ramp run leading to...
-
§ 38.53(a) Clear width
(a) Clear width.
-
§ 38.73(a) Clear width
(a) Clear width—
-
§ 38.113 Doorways
[See subsections ...]
