Accessible means, with respect to vehicles and facilities, complying with the accessibility requirements of parts 37 and 38 of this title....
Search Results "Access Aisle Width"
Commonly Searched Documents
-
§ 37.3 Accessible
-
Minimum Clear Corridor Width
A few commenters from the disability community advocated a minimum clear corridor width of 48 inches....
-
9.5.2(2)(a)
(a) at least one public entrance shall allow a person with mobility impairments to approach, enter and exit including a minimum clear door width of 32 in (815 mm)....
-
Must accessible routes or crossings be marked?
The ADA Standards require accessible parking spaces and access aisles to be marked, but they do not require accessible routes, including portions crossing vehicular ways, to be marked....
-
What Are the Requirements for Accessible Routes?
What Are the Requirements for Accessible Routes? ADAAG Section 4.3 addresses accessible routes that connect the play area to the school, parking lot, or facility that it serves. ...
-
221.1 General
Assembly areas shall provide wheelchair spaces, companion seats, and designated aisle seats complying with 221 and 802. In addition, lawn seating shall comply with 221.5....
- Figure 703.7.2.2 International Symbol of TTY – Drawing from the U.S. Access Board
- Figure 703.7.2.3 Volume Control Telephone – Drawing from the U.S. Access Board
-
(1)(e)
(e) Doorways on the end of the enclosure, opposite the water closet, should have a minimum clear opening width of 32 inches (815 mm)....
-
I. Slip Resistant Surface—Aisles, Steps, Floor Areas Where People Walk, Floor Areas in Securement Locations, Lift Platforms, Ramps
Slip Resistant Surface—Aisles, Steps, Floor Areas Where People Walk, Floor Areas in Securement Locations, Lift Platforms, Ramps Slip resistance is based on the frictional force necessary...
-
11B-227.5 Queues and Waiting Lines
Queues and waiting lines servicing counters or check-out aisles required to comply with Sections 11B-904.3 or 11B-904.4 shall comply with Section 11B-403 _|Walking Surfaces|_. ...
-
§ 38.23(c)(2) Ramp surface
The ramp surface shall be continuous and slip resistant; shall not have protrusions from the surface greater than 1/4 inch high; shall have a clear width of 30 inches; and shall accommodate...
-
§ 38.83(c)(2) Ramp surface
The ramp or bridge plate surface shall be continuous and slip resistant, shall not have protrusions from the surface greater then 1/4 inch, shall have a clear width of 30 inches, and shall...
-
11B-405.8 Handrails
Ramps not subject to the exception to 405.5 shall be designed to maintain a 36 inch (915 mm) minimum clear width when handrails are installed....
-
11B-227.5 Queues and Waiting Lines
Queues and waiting lines servicing counters or check-out aisles required to comply with Sections 11B-904.3 or 11B-904.4 shall comply with Section 11B-403 _|Walking Surfaces|_. ...
-
Measuring Door Openings
This measures the clear width of the door opening through which people pass, which is less than the width of the door itself....
-
§ 36.304(b)(8)
(8) Widening doors;
-
Sec.36.304(b)(8)
(8) Widening doors;
-
4.1.6(4)(d)
(d) Doors. (i) Where existing elements prohibit strict compliance with the clearance requirements of 4.13.5, a projection of 5/8 in (16 mm) maximum will be permitted for the latch...
-
§100.205(c)(2)
(2) All the doors designed to allow passage into and within all premises are sufficiently wide to allow passage by handicapped persons in wheelchairs; and
-
§ 38.53(a)(1)
(1) Passenger doorways on vehicle sides shall have clear openings at least 32 inches wide when open.
-
§ 38.153(c)
(c)
-
Accessible Routes
Accessible Routes Accessible routes are continuous, unobstructed paths connecting all accessible elements and spaces of a building or facility....
- Access Trax: Accessible Beach and Outdoor Event Mats