Places of assembly 4.31 If provided in the facility or at the site....
Search Results "Site Arrival Point"
Filters
Commonly Searched Documents
-
13. Places of assembly
-
4.3.2(2)
(2) At least one accessible route shall connect accessible buildings, facilities, elements, and spaces that are on the same site....
-
11B-608.2.2 Standard roll-in type shower compartments
Standard roll-in type shower compartments shall be 30 inches (762 mm) wide minimum by 60 inches (1524 mm) deep minimum clear inside dimensions measured at center points of opposing sides...
-
903.4 Back Support
Back support shall be 42 inches (1065 mm) long minimum and shall extend from a point 2 inches (51 mm) maximum above the seat surface to a point 18 inches (455 mm) minimum above the seat...
-
11B-608.2.2 Standard roll-in type shower compartments
Standard roll-in type shower compartments shall be 30 inches (762 mm) wide minimum by 60 inches (1524 mm) deep minimum clear inside dimensions measured at center points of opposing sides...
-
Adding an elevator for barrier removal trigger POT upgrades?
Site topography requires removal of barrier by adding an elevator, does this trigger POT upgrades to the area of work? ...
-
Side reach (Section-by-Section Analysis)
, or exterior site must be placed at an accessible height....
-
Side reach (Section-by-Section Analysis)
, or exterior site must be placed at an accessible height....
-
PROVIDING ACCESSIBLE POLLING PLACES
For example, the only suitable polling site in a precinct might be an inaccessible building. ...
-
Viewing Areas
Because overlooks and viewing areas are destination points, they must be accessible so all visitors can enjoy the viewing opportunities....
-
1.6.8 Facility.
or personal property or interest in such property. (49 CFR § 27.5). 1.6.8.2 For purposes of Title II of the ADA, the term “facility” means any or all portions of buildings, structures, sites...
-
Pit Toilet
Pit toilets are provided primarily for resource protection and are only constructed at recreation sites with a Recreation Site Development Scale level of 2 of less....
-
4.1.1(4) Temporary Structures
, temporary classrooms, bleacher areas, exhibit areas, temporary banking facilities, temporary health screening services, or temporary safe pedestrian passageways around a construction site...
-
Pit Toilet
Pit toilets are provided primarily for resource protection and only are constructed at recreation sites with a Recreation Site Development Scale level of 2 of less....
-
Pit Toilet
Pit toilets are provided primarily for resource protection and are only constructed at recreation sites with a Recreation Site Development Scale level of 2 of less....
-
Prohibited Reduction in Access
For example, if an alteration will reduce the number of parking spaces on a site, accessible parking spaces can be proportionately reduced as long as the minimum required in new construction...
-
DEPARTMENT OF TRANSPORTATION DISABILITY LAW GUIDANCE: Origin-to-Destination Service
of origin to their point of destination....
-
11B-232.2.1.3 Substitute cells
substitute cells (cells other than those where alterations are originally planned), provided that each substitute cell meets the following conditions: Located within the same prison site...
-
11B-503.5 Vertical clearance
The minimum vertical clearance at designated passenger drop-off and loading zones, and along at least one vehicle access route to the area from site entrances and exits, is 114 inches....
-
11B-216.5.1 Parking spaces
Where a total of four or fewer parking spaces, including accessible parking spaces, are provided on a site, identification of accessible parking spaces shall not be required....
-
Accessible Means of Egress
A continuous and unobstructed way of egress travel from any point in a building or facility that provides an accessible route to an area of refuge, a horizontal exit, or a public way....
-
106.5.2 Accessible Means of Egress
A continuous and unobstructed way of egress travel from any point in a building or facility that provides an accessible route to an area of refuge, a horizontal exit, or a public way....
-
5.1.4 Transfer Surface Height Measurement
The transfer surface height should be measured from the floor to the highest point on the seat in an uncompressed state, inclusive of bolsters....
-
502.3.13 Modification of Focus Cursor
Focus, text insertion point, and selection attributes that can be set by the user shall be capable of being set programmatically, including through the use of assistive technology....