Openings in floor or ground surfaces shall not allow passage of a sphere more than ½ inch (12.7 mm) diameter except as allowed in Sections 11B-407.4.3, 11B-409.4.3, 11B-410.4, 11B-810.5.3...
Search Results "Surface Slope"
Commonly Searched Documents
-
11B-302.3 Openings
-
7. Commit to Ongoing Maintenance of Accessible Playground Surfaces as a Responsibility of Ownership
One site utilizing PIP as the primary access route and EWF as the secondary access route was assessed with less than 1 percent slope at the transition between the two surface materials....
- NanoPave® 2-in-1 Joint Stabilizer and Sealer
-
A4.5.3 Carpet
Much more needs to be done in developing both quantitative and qualitative criteria for carpeting (i.e., problems associated with texture and weave need to be studied). However,...
-
Carpet [§302.2]
Carpet [§302.2] Carpet that is thick, cushiony, or loose impairs accessibility, particularly wheelchair maneuvering. The standards specify the maximum pile height (1/2” measured...
-
14) Carpet and carpet tile
14) Carpet and carpet tile ADAAG: Same standards for carpet and carpet tile: maximum pile height of 1/2" (§4.5.3). UFAS: Carpet must have maximum pile height of 1/2". Carpet...
-
3. Review the Research Findings About Accessibility Issues for Play Surfaces
Deficiencies (excessive running slope, cross slope, change in level, or openings) for PIP, TIL and HYB began to emerge 24-36 months after installation....
-
11B-302.3 Openings
Openings in floor or ground surfaces shall not allow passage of a sphere more than ½ inch (12.7 mm) diameter except as allowed in Sections 11B-407.4.3 _|Platform to Hoistway Clearance|_,...
-
(3) Adjustability: Transfer Surface Intermediate Heights
In the MDE NPRM there was no requirement for the transfer surface to have intermediate transfer heights....
-
1133A.4.1, Item 4
Finished flooring shall be extended to the wall beneath the sink and work surface....
-
Acceptable SEWF Systems
Because of their reactivity, the stabilizing binders needed to be applied on site or mixed with EWF no longer than 1 h prior to placement on the ground surface....
-
II. Research Methodology
By 2007 installation of surface materials for testing was begun at Bradford Woods located at Indiana University....
-
III. Results of the Study
Results of the Study The purpose of the longitudinal study was to evaluate a variety of aggregate and organic or natural byproduct soil stabilizer trail surface materials for their ability...
-
Moisture and Durability
these surfacing systems....
-
T302 Walking Surfaces
The technical requirements for walking surfaces include provisions on slip resistance, the maximum size of surface openings, and the maximum height of vertical surface discontinuities (i.e...
-
11B-306.3.3 Minimum required depth
At dining and work surfaces required to be accessible by Section 11B-226.1, knee clearance shall extend 19 inches (483 mm) deep minimum at 27 inches (686 mm) above the finish floor or ground...
-
4.2.2 Cooking Surface Height
The cooking surface shall be at least 15 inches (380 mm) and no more than 34 inches (865 mm) above the floor or ground surface. ...
-
809.2.1.2 Floor Surfaces
809.2.1.2 Floor Surfaces This section specifies that carpet not be provided on floor surfaces in emergency transportable housing units with mobility features....
-
RECOMMENDATIONS
RECOMMENDATIONS An objective test procedure for measuring the firmness and stability of surfaces with a portable device and performance specifications need to be accepted in order to...
-
11B-812.3 Floor or ground surfaces
Changes in level, slopes exceeding 1:48, and detectable warnings shall not be permitted....
-
Exposed Pipes and Surfaces [4.19.4]
Exposed Pipes and Surfaces [4.19.4] To prevent burns, hot water pipes and drain pipes under lavatories must be insulated or otherwise configured to protect against contact....
-
606.5 Exposed Pipes and Surfaces
606.5 Exposed Pipes and Surfaces. Water supply and drain pipes under lavatories and sinks shall be insulated or otherwise configured to protect against contact....
- Sargent NB8700 Top Latch Surface Vertical Rod Exit Device
-
804.3 Kitchen Work Surface
804.3 Kitchen Work Surface....