Search Results "Head Height"

• Federal Documents > Preamble to Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment - Preamble
  M301.2.4 Unobstructed Transfer (Section-by-Section Analysis)

  In the MDE NPRM the Access Board proposed that each transfer side provide unobstructed access to the transfer surface, with an exception to permit temporary obstructions as long as...

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM
  M301.4 Lift Compatibility

  Diagnostic equipment shall be usable with a patient lift and shall comply with M301.4.1 or M301.4.2.

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM
  M301.2.3 Transfer Sides

  The transfer surface shall be located to provide options to transfer from a mobility device onto one short side (depth) and one long side (width) of the surface. Each transfer side...

• Federal Documents > Preamble to Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment - Preamble
  M305.2.2 Length (Section-by-Section Analysis)

  Advisory Committee also recommended 15 inches in length stating that this would provide continuous support for patients and still accommodate the articulation that is necessary for the head...

• Research and History > Research Documents > Independent Wheelchair Transfers in the Built Environment: How Transfer Setup Impacts Performance Phase 2: Final Report
  Protocol B Heights Obtained

  Again for the minimum height protocol HERL participants transferred lower on average than the NDVWSC participants....

• State and Local Documents > Codes and Standards > 2016 California Standards for Accessible Design Pocket Guide - Eff. Jan. 1, 2017
  11B-611.4 Height

  11B-611.4 Height. Top loading machines shall have the door to the laundry compartment located 36 inches (914 mm) maximum above the finish floor....

• Webinars, Videos, and Training > Official Technical Assistance
  Access Board: Signs
  

• State and Local Documents > Codes and Standards > 2013 California Standards for Accessible Design Pocket Guide
  11B-611.4 Height

  FIGURE 11B-611.4 HEIGHT OF LAUNDRY COMPARTMENT OPENING...

• Federal Documents > Standards > 36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment
  M301 Diagnostic Equipment Used by Patients in Supine, Prone, or Side-Lying Position

  [See subsections ...]

• Additional Access Publications > Health Access for Independent Living (HAIL) Fact Sheet: Working with Your Health Care Provider
  How Can You Overcome These Barriers to Work with Your Providers?

  There are many things that a person with a disability can do to improve his or her quality of health care and break down the barriers that compromise care. The following suggestions...

• Rulemaking Process Documents > NPRMS > 36 CFR Part 1195 Proposed Accessibility Standards for Medical Diagnostic Equipment NPRM
  M301 Diagnostic Equipment Used by Patients in Supine, Prone, or Side-Lying Position

  [See subsections ...]

• Research and History > Research Documents > Standards and Anthropometry for Wheeled Mobility
  Appendix 3 - Comparison of US Standards to IDEA Center Research

  (HH) 915 80 895 754 1024   Armrest Height (AH) 760...

• Webinars, Videos, and Training > Spirit of the ADA
  Boost Your Business - Chapter 11 - Stairs
  

  Boost Your Business - Chapter 11 - Stairs

• Additional Access Publications > ADA Checklist for Existing Facilities
  Priority 2: Access to Goods & Services

    Word Fillable Form (2.5MB) Word Non-Fillable Form (2.4MB) PDF Non-Fillable Form (1.4MB)

• Research and History > Research Documents > Anthropometry of Wheeled Mobility Project: Final Report
  3.3.7 Toe Clearance Height, minimum

  3.3.7 Toe Clearance Height, minimum There is relatively large disparity between the standards for toe clearance height, with the U.S. having the lowest (230 mm or 9 in.), followed by...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  COSTS TO LOWER MINIMUM TABLE HEIGHT

  COSTS TO LOWER MINIMUM TABLE HEIGHT To be useful for its intended purpose, examination tables and chairs must maintain a high height of at least 32 inches, so that the health care provider...

• Rulemaking Process Documents > Committee Activity and Reports > Recommendations on Standards for the Design of Medical Diagnostic Equipment for Adults with Disabilities, Advisory Committee Final Report
  HOW TO MEASURE TRANSFER HEIGHTS IS IMPORTANT

  HOW TO MEASURE TRANSFER HEIGHTS IS IMPORTANT Many medical examination rooms are equipped with fixed height examination tables, with a typical 32-inch seat height....

• Federal Documents > Preamble to Guidelines > 36 CFR Parts 1190 and 1191 ADA and ABA Accessibility Guidelines - Preamble (Discussion of Comments and Changes)
  Water Flow Height

  The minimum 4 inch height is intended to allow use of cups for persons who may need to use them....

• Research and History > Research Documents > Anthropometry of Wheeled Mobility Project: Final Report
  3.3.6 Knee Clearance Height, minimum

  3.3.6 Knee Clearance Height, minimum Knee clearance heights for the four sets of standards range from 650 mm (25.6 in.) (Australia) to 700 mm (27.6 in.) (U.K.) (Figure 3‒6)....