Clearances are measured from the furthest projecting face of all opposing base cabinets, counter tops, appliances, or walls, excluding hardware. ◼...
Search Results "Head End Wall"
Filters
Commonly Searched Documents
-
11B-804.2 Clearance
-
11B-903.6 Structural strength
Benches shall be affixed to the wall or floor....
-
§ 37.131(a)(2)(ii)
(ii) At end stations and other stations in outlying areas, the entity may designate circles with radii of up to 11/2 miles as part of its service area, based on local circumstances....
-
Kohler Veil™ One-Piece Elongated Dual-Flush Wall-Hung Toilet With Reveal® Quiet-Close™ Seat
Requires the Premium User plan or above. (Login or upgrade your account!) -
30.1 Q. Would it be acceptable to use removable base cabinets beneath a wall-hung lavatory where a parallel approach is not possible?
A. Yes. The space under and around the cabinet should be finished prior to installation. For example, the tile or other floor finish must extend under the removable base cabinet.
-
2010 ADA Standards
All dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end points....
-
104.1.1 Construction and Manufacturing Tolerances
All dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end points....
-
104.1.1 Construction and Manufacturing Tolerances
All dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end points....
-
M301.2.3 Size (Section-by-Section Analysis)
discussed in Section IV.B.1.c (Significant Changes – Transfer Surface Size), in the final rule the Access Board has revised this provision to account for the two types of transfer surfaces (end...
-
A.2.ii. - Should EIT be compatible with assistive technology?
These products, such as information kiosks, copiers, or other similar products that do not permit a user to install or connect assistive technology, must be designed so that an end user...
-
Common Problems with Toilet Rooms
Ø The "accessible" toilet is placed too close or too far from the wall or stall divider. ...
-
11. Gap
Is the gap between the wall and the inside face of each grab bar exactly 1 1/2" to accommodate persons with disabilities who rest their forearms on the bars for stabilization so the arm...
-
1k
Is the gap between the wall and the inside face of each grab bar exactly 1 1/2" to accommodate persons with disabilities who rest their forearms on the bars for stabilization so the arm...
-
1134A.7 Water closets
Exception: The 48-inch (1219 mm) minimum clear width may be reduced to 36 inches (914 mm) for lavatories, cabinets, wing walls, or privacy walls located immediately adjacent to a water closet...
-
Olympia i2 Single Handle Pull-Down Kitchen Faucet K-5020
Single Handle Pull-Down Kitchen Faucet Lever Handle Pull-Down Head with 2 Spray Patterns Swivel 360° 7-5/8″ Reach, 8-5/8″ From Deck to Aerator Ceramic...
-
Olympia i2 Single Handle Pull-Down Kitchen Faucet K-5025
Single Handle Pull-Down Kitchen Faucet Lever Handle Pull-Down Head with 2 Spray Patterns Swivel 360⁰ 7-5/8″ Reach, 8-3/4″ From Deck to Aerator Ceramic...
-
1. Common Problems and Solutions in Website Accessibility
Resources providing more detailed information on accessible website design are provided at the end of this Chapter....
-
Terminal
Device or software with which the end user directly interacts and that provides the user interface....
-
Terminal
Device or software with which the end user directly interacts and that provides the user interface....
-
Terminal
Device or software with which the end user directly interacts and that provides the user interface....
-
Terminal
Device or software with which the end user directly interacts and that provides the user interface....
-
Hallways
ADA Requirements Wall-mounted objects located between 27 inches and 80 inches above the floor may not protrude or stick out from the wall more than 4 inches....
-
704.3 Buildings on the same property and buildings containing courts
For the purposes of determining the required wall and opening protection and roof-covering requirements, buildings on the same property and court walls of buildings over one story in height...
-
11B-604.3.1 Size
Clearance around a water closet shall be 60 inches (1524 mm) minimum measured perpendicular from the side wall and 56 inches (1422 mm) minimum measured perpendicular from the rear wall....
