Coat hooks provided within the room shall be located within one of the reach ranges specified in 308....
Search Results "Dimension Range"
-
803.5 Coat Hooks and Shelves
-
606.1 General
If soap and towel dispensers are provided, they must be located within the reach ranges specified in 308....
-
11B-227.4 Food service lines
Where self-service shelves are provided, at least 50 percent, but no fewer than one, of each type provided shall comply with Section 11B-308 _|Reach Ranges|_. ...
-
Guidelines for Requirement 7
The Department has eliminated the specification that controls for ranges and cooktops be placed so that reaching across burners is not required....
-
Mounting Height and Location
The proposed rule specified a range of height of 48 to 60 inches for raised characters and a range of 40 to 60 inches for braille....
-
Protrusion Limits: ADA Standard Section 307.2
Section 307.2 covers the current ADA Standards for protrusion limits.
-
Height: ADA Standard Section 704.4.1
the required 34 inches (865 mm) minimum keypad height can causes the highest operable part of the telephone, usually the coin slot, to exceed the maximum permitted side and forward reach ranges...
-
11B-809.9.2 Clear width
U-shaped kitchens, designed with parallel approach at a sink, range, cooktop or other fixtures and appliances located at the base of the U without knee and toe clearance, shall provide a...
-
11B-307.2 Protrusion limits
When a cane is used and the element is in the detectable range, it gives a person sufficient time to detect the element with the cane before there is body contact....
-
11B-307.2 Protrusion limits
When a cane is used and the element is in the detectable range, it gives a person sufficient time to detect the element with the cane before there is body contact....
-
11B-809.9.2 Clear width
U-shaped kitchens, designed with parallel approach at a sink, range, cooktop or other fixtures and appliances located at the base of the U without knee and toe clearance, shall provide a...
-
(5) the City's policy as stated on its website
website that an "accessible" park need provide only an "accessible entrance" and "at last one recreational opportunity," and which does not require the provision of accessible routes to the range...
-
604.8.3 Coat Hooks and Shelves
Coat hooks shall be located within one of the reach ranges specified in 308....
-
603.4 Coat Hooks and Shelves
Coat hooks shall be located within one of the reach ranges specified in 308....
-
Digital Human Models
Such models can represent an individual of specific dimension, or can represent whole groups of individuals....
-
Character Specifications
For those with non-rectangular cross sections, this range applied to the top of the cross section and a range of 1/16 inch to d inch was permitted at the base....
-
Interpreting the Interactions
People in the 20/20, 20/60 range, the average contrast sensitivity is in the range of 1.2 and you can see contrast sensitivity just declines with each of the acuity tabs (slide 45)....
-
603.4 Coat Hooks and Shelves
Coat hooks shall be located within one of the reach ranges specified in 308....
-
606.1 General
If soap and towel dispensers are provided, they must be located within the reach ranges specified in 308....
-
608.2.1 Transfer Type Shower Compartments
Transfer type shower compartments shall be 36 inches (915 mm) by 36 inches (915 mm) clear inside dimensions measured at the center points of opposing sides and shall have a 36 inch (915...
-
Urinal Depth
In the proposed rule, the Board sought to clarify the requirement in the original ADAAG that accessible urinals have an "elongated" rim by specifying a minimum dimension of 13 ½ inches,...
-
5.2.1.4 Transfer Surface Size for Imaging Equipment
The transfer surface should be located such that the long dimension of 28 inches is located parallel to the patient scanning/imaging side of the table....
-
407.12.3.1 Unobstructed Forward Reach (Section-by-Section Analysis)
These dimensions and their resulting geometry are consistent with the ADA and ABA Accessibility Guidelines (36 CFR Part 1191, Appendix D, sections 306 and 308)....
-
4.10.3 Hall Call Buttons
Call buttons shall be a minimum of 3/4 in (19 mm) in the smallest dimension. The button designating the up direction shall be on top. (See Fig. 20.) Buttons shall be raised or flush....