Faucets and other controls complying with 4.27.4 shall be located as shown in Fig. 37. In shower stalls 36 in by 36 in (915 mm by 915 mm), all controls, faucets, and the shower unit...
Search Results "Alternate Door"
-
4.21.5 Controls
-
4.21.5 CONTROLS
Faucets and other controls complying with 4.27.4 shall be located as shown in Fig. 37. In shower stalls 36 in by 36 in (915 mm by 915 mm), all controls, faucets, and the shower unit...
-
15(d)
(d) Within the timeframe set forth in subparagraph 15(a), HWI shall ensure that each Post-1993 Owned Hotel and Post-1993 Joint Venture Hotel has the required number of accessible...
-
Thresholds [§404.2.5]
These requirements apply to all types of doors required to comply, including sliding doors. Threshold Profile...
-
§ 38.107(a)(5)
Door latches and hardware shall be operable with one hand and shall not require tight grasping, pinching, or twisting of the wrist....
-
803 Dressing, Fitting, and Locker Rooms
In the proposed rule, an exception to this provision noted that a portion of this space (6 inches maximum) could extend under partitions or openings without doors that provide toe clearance...
- Figure 608.5.3 Alternate Roll-In Type Shower Compartment Control Location – Drawing from the U.S. Access Board
- Panda S.10 All Aluminum Lift & Slide - Pocket Door System
- S.74 Aluminum Wood Clad Folding Door System Corner Detail
- Panda S.65 Aluminum Wood Clad Multi Slide Door System
- Panda S.65 Aluminum with Aluminum Clad Multi Slide Door System
- Panda TS.60 Thermally Broken Folding Door System Video 2
- Panda TS.60 Thermally Broken Folding Door System Video 1
- Panda S.10 All Aluminum Lift & Slide - Stackable Door System
-
11B-207.1 General
Doors that provide access only to interior or exterior stairways shall not be required to comply with Section 11B-404....
-
End-of-Row Stalls
If an out swinging door is provided at an end-of-row stall, maneuvering space of at least 18 inches at the latch side pull side must be provided....
-
1132A.7 Type of lock or latch
The type of latch and lock required for all doors shall be in accordance with Section 1132A.8 and Chapter 10, Section 1008....
-
1132A.7 Type of lock or latch
The type of latch and lock required for all doors shall be in accordance with Section 1132A.8 and Chapter 10, Section 1008....
-
On-Site Readers
Sometimes, in spite of great planning, there is last-minute material that does not get converted into alternate formats....
-
Building Entrance
At least one door at the accessible entrance must have a minimum clear width of 32 inches for a voter who uses a wheelchair or other mobility device to pass through the doorway....
-
11B-603.2.3 Door swing
11B-603.2.3 Door swing. Doors shall not swing into the clear floor space or clearance required for any fixture....
-
11B-603.2.3 Door swing
Other than the door to the accessible water closet compartment, a door in any position, may encroach into the turning space by 12 inches (305 mm) maximum....
-
11B-603.2.3 Door swing
[2010 ADA Standards] 603.2.3 Door Swing. Doors shall not swing into the clear floor space or clearance required for any fixture....
-
1132A.7 Type of lock or latch
The type of latch and lock required for all doors shall be in accordance with Section 1132A.8 and Chapter 10, Section 1008....