For a unique look, design your own custom shape....
Search Results "U-Shaped Grab Bar"
Filters
Commonly Searched Documents
-
Activar Hiawatha HG111 & HG112 Straight Tubular Pulls and HG113 & HG114 Push Bars
-
Results comparison with current accessibility guidelines
Our subjects preferred the front grab bar height to be between 30-33” (76.2 and 83.8 cm). Table 13 ....
-
Outdoor Developed Areas: A Summary of Accessibility Standards for Federal Outdoor Developed Areas
Acknowledgments The Architectural and Transportation Barriers Compliance Board (Access Board) developed the accessibility guidelines for trails, camping and picnic facilities,...
-
1134A.5 Bathtubs
Reinforced walls for grab bars. A bathtub installed without surrounding walls shall provide reinforced areas for the installation of floor-mounted grab bars....
-
11B-608.5.3 Alternate roll-in type shower compartments
The controls, faucets, and shower spray units shall be located above the grab bar, but no higher than 48 inches (1219 mm) above the shower floor....
-
Plan 5B: 13-Foot Wide Accessible Guest Room
(section 607.2); • Lavatory with vanity counter top recessed to permit shorter rear grab bar at water closet (section 604.5.2); • T-shaped turning space in room (section 603.2.1);...
-
604.7 Dispensers
The outlet of the dispenser shall be 15 inches (380 mm) minimum and 48 inches (1220 mm) maximum above the finish floor and shall not be located behind grab bars....
-
604.7 Dispensers
The outlet of the dispenser shall be 15 inches (380 mm) minimum and 48 inches (1220 mm) maximum above the finish floor and shall not be located behind grab bars....
-
Gates, Bars, and Berms
Forest Service-constructed barriers on pedestrian travel routes must have a 32-inch minimum width gap or include a route beside them that will permit passage of a wheelchair....
-
RECOMMENDATIONS
Permit rear or floor mounted swing-away grab bars on both sides of the toilet....
-
Cross Section of Gripping Surfaces
The 2004 ADA and ABA Accessibility Guidelines specify the following dimensions for grab bars to enable individuals with disabilities to firmly grasp the grab bars and support themselves...
-
604.7 Dispensers
The outlet of the dispenser shall be 15 inches (380 mm) minimum and 48 inches (1220 mm) maximum above the finish floor and shall not be located behind grab bars....
-
5.4.6 Transfer Support Gripping Surface Cross Section and Clearances for M301, M302, and M305.2
NPRM Preamble Discussion: The 2010 Standards specify the following dimensions for grab bars to enable individuals with disabilities to firmly grasp the grab bars and support themselves during...
-
604.7 Dispensers
The outlet of the dispenser shall be 15 inches (380 mm) minimum and 48 inches (1220 mm) maximum above the finish floor and shall not be located behind grab bars....
-
Types of Alternative Designs
The positioning and type of grab bars were also changed to provide more room and flexibility....
-
Space Needs
Maximum Height: No Grab Bars/No Backrest Angle (degrees) 0.0 18.0 30.0 53.0 90.0 90.0...
-
604 Water Closets and Toilet Compartments
Revisions to the requirements for water closets concern: location (604.2) clearance (604.3) grab bars (604.5) flush controls (604.6) dispensers (...
-
Size and Clearances [4.21.2]
The 36 by 36 inch dimension, measured to the interior finish, keeps front and side grab bars within reach from the seat....
-
1607.8 Loads on handrails, guards, grab bars shower seats, dressing room bench seats and seats
[See subsections ...]
-
Is latch-side maneuvering clearance as specified in the Standards applicable to doors with panic bars?
maneuvering clearances specified for a door, including on the push side of doors with a forward approach that have both a closer and latch, it must be provided at manual doors with panic bars...
-
Standard Roll-In Type Shower Compartments: ADA Standard Section 608.5.2
Section 608.5.2 covers the current ADA Standards for controls in standard roll-in type shower compartments.
-
Alternate Roll-In Type Shower Compartments: ADA Standard Section 608.5.3
Section 608.5.3 covers the current ADA Standards for controls in alternate roll-in type shower compartments.
-
Measures and Procedures
bar (fixed height of 32” or 81.3 cm) and allows for attaching/detaching side guards (e.g. obstacle to transfer) and an optional front grab bar of varying height (Figure 1) of 19”-38” (48.3...
-
Roadtech Manufacturing Retractable Cone Bar Barricades and Barriers
Retractable Cone Bar Barricades and Barriers Pedestrian Barricades | Traffic Control Barricades | Safety Barrier The JBC Retractable Cone-Bar Barricade is...
