The term “supported employment,” which has been applied to a wide variety of programs to assist individuals with severe disabilities in both competitive and non-competitive employment, is...
Search Results "Support"
Commonly Searched Documents
-
Section 1630.9 Not Making Reasonable Accommodation
-
4.3.2 Transfer Surfaces and Imaging Equipment Functions
Its unique design must accommodate a physician underneath the patient support surface....
-
The Brewer Company, LLC
It is certain that the addition of transfer supports and leg supports will add to the product cost....
- Moen Fold Down Shower Seat
-
A. Existing 508 Standards and 255 Guidelines (1998-2000)
functional performance criteria for covered information and technologies; require agencies to document undue burden determinations when procuring covered products; and mandate accessibility of support...
-
4.3.5 Patient Positions During Diagnostic Imaging
Industry representatives on the Committee suggested that the standing supports would likely need to be an accessory or a mounting in the room....
- Acoustiguide Custom Multimedia Content Application
-
307.2 Protrusion Limits
For example, awnings and their supporting structures cannot reduce the minimum required vertical clearance....
-
Section 1193.35 Redundancy and Selectability [1193.33 in the NPRM] (Section-by-Section Analysis)
Although this provision was supported by persons with disabilities, it may run contrary to section 1193.41 (i), which intends to make products accessible to persons with limited cognitive...
-
11B-307.2 Protrusion limits
For example, awnings and their supporting structures cannot reduce the minimum required vertical clearance....
-
307.2 Protrusion Limits
For example, awnings and their supporting structures cannot reduce the minimum required vertical clearance....
-
604.8.1.4 Toe Clearance
provide a toe clearance of 9 inches (230 mm) minimum above the finish floor and 6 inches (150 mm) deep minimum beyond the compartment-side face of the partition, exclusive of partition support...
-
Purpose
In support of this effort, the Department is announcing its intention to adopt standards consistent with Parts I and III of the 2004 ADAAG as the ADA Standards for Accessible Design. ...
-
Purpose
In support of this effort, the Department is announcing its intention to adopt standards consistent with Parts I and III of the 2004 ADAAG as the ADA Standards for Accessible Design. ...
-
T202 Accessible Means of Boarding and Alighting
Only two commenters expressed views on this scoping section, and both supported the Access Board’s inclusion of requirements for level boarding bus systems....
-
504.2 Content Creation or Editing
edit content that conforms to all Level A and Level AA Success Criteria and all Conformance Requirements in WCAG 2.0 (incorporated by reference in Chapter 1) for all features and formats supported...
-
Clear Floor Space [4.2.4]
Clearances are measured in relation to the usable clear floor space, not necessarily to the vertical support....
-
Clear Floor Space [4.35.2]
Placing the bench in a corner will allow the walls to be used as support or as a backrest....
-
Epilogue
legislative successes offering momentum; legal and lobbying expertise in the disability community; the willingness of persons with disabilities to unite for a common cause; the cautious support...
-
Section 36.208(a) (Section-By-Section Analysis and Response to Comments)
Commenters representing individuals with disabilities generally supported this provision, but suggested revisions to further limit its application....
- Pressalit Care PLUS - Bathroom Product Range Overview
- Meet Bruce Cast Video (open captions with audio introduction)
- Bobrick Charting Station/Shelf B-7816
- AJW Architectural Products US130-A Series US130-A12 12" Exposed Flange, 1.5" Diameter Security Grab Bar - Configuration A