Those portions of accessible routes that slope more than 1:20 must be treated as ramps or curb ramps. Comment....
Search Results "Ramp Handrail"
Filters
Commonly Searched Documents
-
402 Accessible Routes
-
General (R304.1) (Section-by-Section Analysis)
General (R304.1) (Section-by-Section Analysis) Curb ramps are ramps that are cut through or built up to the curb (see R105.5)....
-
d-vi
Does the ramp have a level landing that is at least 60 inches long at the top and bottom of each ramp section or where the ramp changes direction?...
-
406.8--Modification to 406 of Appendix D to 36 CFR Part 1191
406.8--Modification to 406 of Appendix D to 36 CFR Part 1191 A curb ramp shall have a detectable warning complying with 705....
-
M303.3.3 Ramped (Section-by-Section Analysis)
technical requirements for running slope, cross slope, clear width, edge protection, and handrails....
-
11B-406.5.6 Grade breaks
Grade breaks at the top and bottom of curb ramp runs shall be perpendicular to the direction of the ramp run....
-
11B-406.5.6 Grade breaks
Grade breaks at the top and bottom of curb ramp runs shall be perpendicular to the direction of the ramp run....
-
11B-406.5.6 Grade breaks
Grade breaks at the top and bottom of curb ramp runs shall be perpendicular to the direction of the ramp run....
-
R304.5.2 Grade Breaks
Grade breaks at the top and bottom of curb ramp runs shall be perpendicular to the direction of the ramp run....
-
11B-405.7.4 Change in direction
ramp run. ...
-
T207.2 Passenger Doorways
Handrails or stanchions shall be provided at passenger doorways in a configuration that permits grasping and use from outside the non-rail vehicle and throughout the boarding and alighting...
-
§ 38.83(c)(6)(i) Requirement
When in use for boarding or alighting, the ramp or bridge plate shall be attached to the vehicle, or otherwise prevented from moving such that it is not subject to displacement when loading...
-
Common Use Circulation Paths in Employee Work Areas
• Handrails are not required on ramps, provided that they can be added in the future....
-
Common Requirements (R304.5) (Section-by-Section Analysis)
Grade breaks at the top and bottom of curb ramp runs must be perpendicular to the direction of the ramp run....
-
11B-405.4 Floor or ground surfaces
Floor or ground surfaces of ramp runs shall comply with Section 11B-302. Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
11B-405.4 Floor or ground surfaces
Floor or ground surfaces of ramp runs shall comply with Section 11B-302. Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
11B-405.4 Floor or ground surfaces
Floor or ground surfaces of ramp runs shall comply with Section 11B-302. Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
11B-405.7.4 Change in direction
Ramps that change direction between runs at landings shall have a clear landing 60 inches (1525 mm) minimum by 72 inches (1829 mm) minimum in the direction of downward travel from the upper...
-
11B-405.7.4 Change in direction
Ramps that change direction between runs at landings shall have a clear landing 60 inches (1525 mm) minimum by 72 inches (1829 mm) minimum in the direction of downward travel from the upper...
-
A4.8.1 General
Ramps are essential for wheelchair users if elevators or lifts are not available to connect different levels....
-
4.7.9 Location at Marked Crossings
Curb ramps at marked crossings shall be wholly contained within the markings, excluding any flared sides (see Fig. 15). ...
-
A4.8.1 GENERAL
Ramps are essential for wheelchair users if elevators or lifts are not available to connect different levels....
-
4.7.9 LOCATION AT MARKED CROSSINGS
Curb ramps at marked crossings shall be wholly contained within the markings, excluding any flared sides (see Fig. 15). Figure 15 Curb Ramps at Marked Crossings...
-
A4.8.4 Landings
A ramp landing that is not level causes individuals using wheelchairs to tip backward or bottom out when the ramp is approached....